Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: BQ24297 Tool/software: when checking BQ24297 for adapter detection R8:bits 6&7 it fails to detect the adapter if it is removed and reconnected, First time it will display status as 10 – Adapter port, after removing and reconnecting it…
Part Number: BQ24297 Tool/software: During testing of our product we found that some time we get charging fault and battery fault while reading register of charging IC BQ24297.
For charging fault there is detailed description in the register map but…
Part Number: BQ24297 Tool/software: Dear TI experts,
My customer found the issue about adapter detection using BQ24297. Please see the detailed description below.
1. First I attach the schematic for your convenience.
8750.sch1.pdf
2. They use 4 lines…
Part Number: BQ24297
Tool/software:
Dear TI experts,
My customer have a problem that sometimes device does not wake up.
At that time my customer measured the voltage of battery connector (Vbat and GND), they saw 2.5V.
So SYS pin could not make the voltage…
Part Number: BQ24297 Some device using BQ24297 of our company failed in IEC62368-1. Can I get a CB Test Certificate of BQ24297 and a full report report of BQ24297?
Part Number: BQ24297 Issue resolved: SMT had placed RT1/2 resistor value 3.1K instead of 31.6K (as recommended)
---
Hi!
We have manufactured new custom product using BQ24297 power IC. Charging was not triggered due TS resistor configuration.
Status:
IC…
Part Number: BQ24297 Other Parts Discussed in Thread: BQ24296 Hi,
I am using the BQ24297 single-cell charging IC for my product.
I am facing an issue regarding the incorrect detection of the VBUS.
I have connected a 5V, 3Amp adapter to the VBUS pin, but…
Part Number: BQ24297 Other Parts Discussed in Thread: BQ24298 BQ24297 VS BQ24298:
We desinged and tested our pcb where we have pmic charger connected with USB typ C connector.
For de testing we use te reference BQ24297 and BQ24298, The both reference…
Hello,
The register dump provided by Star earlier in the thread indicates that after booting up the current limit is initially set to 500mA.
My best theory for the behavior is that VSYS crashes due to this lower current limit before the software can update…
Part Number: BQ24297 Other Parts Discussed in Thread: BQ24298 This thread is continuation of the previous thread
https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1272423/bq24298-interface-with-usb-c-sch-and-i2c…
