Part Number: BQ24308 Tool/software: Hi Ti, We are using the BQ24308DSGR IC. The issue is that when we connect the load, fluctuations occur. On the ILIM pin, we are using a 30.1 kΩ resistor, which limits the current to 1.5 A. We also tried using a 4.7…
Part Number: BQ24308 Other Parts Discussed in Thread: BQ25601D , BQ2980 , BQ2970 Tool/software: Hello,
Could you please recommend a Charger Front-End Protection IC that can be used at the input of BQ25601D charger IC?
I could not find a product that…
Part Number: BQ24308 Hi
The customer design with BQ24308.
At the beginning, when Vin >= 5.1V, Vout will not be able to pull up always, it is pulled Low immediately, repeating all the time.
When use Vin<=5V, Vout output is normal. At this time, increase…
Part Number: BQ24308 Other Parts Discussed in Thread: TINA-TI
Hi,
1. For your datasheet here - https://www.ti.com/lit/ds/symlink/bq24308.pdf - is there a typo on page 14? I believe the PMOS is flipped, since the current as shown is going through…
Part Number: BQ24308 Hi,
I've two questions pertaining BQ24308:
1. In datasheet pg 6, High-level input voltage V(IH) of CE stated the min spec is 1.4V. Does that mean that it requires at least 1.4V to enable the device? Customer of mine encountered…
Part Number: BQ24308 Hi,
I'd like to seek for your advise on the value of tDGL
In my customer application, they have added a reset circuit to control "CE" pin of BQ24308. As a result, we need to have a detail specification on tDGL(PGOOD) : MIN, TYP…
Other Parts Discussed in Thread: BQ24308 Hi Everyone,
Please let me ask about Ron of internal Q1 FET of bq24308. The VDO at 250mA is specified as 75mV max, so I understand that the Ron max at 250mA should be 300mohm. Then is it also the same at 1.5A…
Part Number: BQ24314 Other Parts Discussed in Thread: BQ24308 Hi,
We are using the BQ24314 P.N in our application as an overload and an over voltage protection circuit, see below.
The OUT pin supplies voltage to an electrical circuit with an approximated…
Part Number: BQ24314C Other Parts Discussed in Thread: BQ24308 Hi,
In the datasheet it specifies the the recommendeed operating conditions are:
But then in the appendix 9 it says:
It seems contradictory and misleading. Will my application works…
