Part Number: BQ25300 Tool/software: Hi,
I am using BQ25300 Charger IC my requirement is to monitor the battery voltage while charging (charging input given).It always shows 4.12V Battery when charger input given. When disconnect the charger input 5V…
Part Number: BQ25300 Other Parts Discussed in Thread: BQ25308 Tool/software: Hi, blow is bq25300 charger ckt using in our project.
When Charger is disabling mode, mean not connecting input 5V, it consumes 5- 6mA Current. Sō my device is battery operated…
Part Number: BQ25300 Other Parts Discussed in Thread: BQ25308 Tool/software: Hi ,
i am using BQ25300 for charging the li-ion battery (7800mAH,4.2V).
I am facing the problem when battery is fully drained (0V) Charging is not done and STA LED IS BLINKING…
Part Number: BQ25300 Tool/software: I am using the BQ25300 as one cell NCR18650 charging IC, and the circuit shown below.
The charging voltage is set at 4.2V, and the charging current is set at 2.5A. Input power is 12V. EN is enabled along with power…
Part Number: BQ25300 Hi team,
When the Enable pin is set to H, causing Disable and STAT:H, does the specification state that even if the thermistor pin opens, STAT does not change to BLINK but remains STAT:H (does it not detect Charge fault during Disable…
Part Number: BQ25300 Other Parts Discussed in Thread: TPS63000 Tool/software: Hellow.
When the battery is in UVP (under voltage protection) state, it does not charge.
(When it is not in UVP state, it works normally.)
However , when I disable the…
Part Number: BQ25300 Tool/software: Hello,
We are planning to certify a device with BQ25300RTER
For that we would plan to do the EN 62619 test. The lab asks if TI can provide with functional tests reports for this standard 8.1 part? They say that…
Part Number: BQ25300 Tool/software: Hi team,
When using the device, please stop charging if the temperature is below 2°C and above 43°C.
What are the values of VT1 and VT3 when substituted into the following equations (1) and (2)?
In this case…
Part Number: BQ25300
Tool/software:
Hi all,
I am currently using the BQ25300RTER chip to charge a 1S6P lithium ion battery pack, with the lithium ion cells being INR18650-30Q. Below is a screenshot of the schematic of how this part is being used…
