Part Number: BQ25601D Hi Team,
Just want to check on how much time is needed to finish BC1.2 detection. My customer want to do BC1.2 detection twice to double check the results and they need to add delay between two BC1.2 test. Is 500ms enough to make…
Part Number: BQ25601D Hi Expert,
My customer is using BQ25601D in their project. They are testing termination current and found the actual current is larger than the threshold. The details are shown below:
Temp
Pre-charge current
Termination-volta…
Part Number: BQ25601D Other Parts Discussed in Thread: BQ25601 Hi TI Teams,
Did BQ25601/BQ25601D support PD3.0?
Our new MTK platform tablet project is using a single lithium battery. The charging IC needs to support the maximum charging voltage of 12V…
Part Number: BQ25601D Hi team,
We can see in datasheet, the BQ25601DRTWR Jeita Cool temperature is set to 0-10deg and the customer has requested to change to 0-15deg, do we have some hidden register to modify via register or have any other ideas to modify…
Part Number: BQ25601D Other Parts Discussed in Thread: BQ25601 , , BQ25611D Hi team,
My customer consider use BQ25601D in their project, they get one question about the D+/D- connected between BQ25601, USB, and MCU. Could you help comment how should they…
Part Number: BQ25601D Hi Team,
Can CE pin be pulled down through resistor? customer want to use a 10kohm. In EVM,it is pulled down to Gnd directly.Is there requirement on pull down resistance ?
Thanks
BRs
Given
Part Number: BQ25601D Hi Team,
Just want to ask if there is time requirement to terminate charging when Ibat < termination current. For example, in CV mode, Ibat need to below termination current for 100ms, then the charging will be terminated.
Thanks…
Part Number: BQ25601D Hi, TI expert
A customer has an inquiry while testing the charging IC (BQ25601D).
Q1) A high-frequency noise is generated from the charging circuit during the charging IC operation.
Is there anything to be corrected in the attached…
Part Number: BQ25601D Other Parts Discussed in Thread: BQ25601 Hi Ti
I want to make a charger using the BQ25601.
It operates as Always On, and the battery is attached and detached.
Does the BQ25601 detect that the battery is attached and start charging…
Part Number: BQ25601D Hi Team,
just want to check if just BC1.2 function of BQ25601D is used and no charging function is used, how to config the part?
1. CE_N is pulled to GND
2. no external inductors and capacitors.
3. floating sys, bat
Thanks.
BRs
…