Part Number: BQ25606 Other Parts Discussed in Thread: TPS61030 Hello TI Team,
I am designing a standalone battery charger using the BQ25606. My input current is strictly limited to exactly 500mA, and I suspect there is a mistake in my schematic or component…
Part Number: BQ25606 Hello,
I am experiencing an unexpected behavior with the BQ25606 battery charger regarding the charge current regulation. The actual charge current measured at the battery does not match the expected value computed according to…
Part Number: BQ25606 Dear receivers,
Could you advise my question?
My charging circuitry with BQ25606 is applied to a Li-ion battery pack.
Question
Does the safety timer count at half clock rate while the BQ25606 device and its charging application…
Part Number: BQ25606 Other Parts Discussed in Thread: BQ25616 Tool/software: hi Expert
Currently, I'm using BQ25606. There's a problem now that when the battery voltage is relatively low, it doesn't support high-current loads. Could you please tell…
Part Number: BQ25606 Other Parts Discussed in Thread: BQ25190 Q1. What's the range of ILIM , ICHG , need clarification for acceptable range is actual range ? CAn we go up to 50mA for charging and discharging? TI_BQ25606 .docx TI_BQ25606 .pdf
Q2. Suggest…
Part Number: BQ25606 Dear TI Engineer,
We encountered a problem when using BQ25606, where the charging and non charging states kept switching when it was almost fully charged. The following waveform shows the voltage and current at the USB 5V side…
Part Number: BQ25606 Hello TI Team,
I am currently working on a power design and would appreciate your guidance and support.
Below are the design details:
Input Supply: 5V / 12V DC
Battery Charger IC: BQ25606RGER (1-cell charger with integrated…
Part Number: BQ25606 Tool/software: May I ask the power supply logic of this chip:
when the external power supply(SYS_Power0) is connected, is it the priority to supply power to the system(SYS_Power), or to charge the internal battery(Li_Power) first…
