Part Number: BQ25616 Other Parts Discussed in Thread: BQ25606 , TEST The datasheet for the BQ25606 and BQ25616 states that they have IEC 62368-1 CB Certification. Can I get a copy of the IEC 62368-1 and CB reports?
Chandan,
1. The device automatically terminates the charging cycle when the charging current is below the termination threshold, the battery voltage is above the recharge threshold, and the device is not in DPM mode or thermal regulation. When a fully…
Part Number: BQ25616 Other Parts Discussed in Thread: TEST ,
Hi,
I have the same exact issue as in this thread here:
https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/963322/bq25606-battery-not-present-and-current…
Part Number: BQ25616 Other Parts Discussed in Thread: BQ25060 I understand the BQ25616 states the acceptable reange for ICHG is 300mA to 3A. I also know TI's postion that smaller charge currents should be handled by linear chargers, such as the BQ25060…
Part Number: BQ25616 I am performing a worst case and derating analysis on a circuit that uses BQ25616RTWR. I can't find a description of how the ILIM, ICHG, nor VSET pins are implemented in order to determine if I am meeting the ratings of my pull down…
Part Number: BQ25616 Other Parts Discussed in Thread: BQ25606 Hello,
Currently our CM wants to replace the BQ25606RGER with the BQ25616 equivalent.
There would be no changes to the PCB – just a straight replacement.
It looks like the differences…
Hi,
The input current limit detection results supported by the BQ25616 is listed in Table 9-2. Input Current Limit Setting from D+/D– Detection on the d/s. If the desired input current limit setting is not available, please leave D+/D- pins open and…
I have already found and solved the problem. The fault was in the ground of the Vref capacitor, which was connected to the power ground instead of the analog ground. Once the charger was connected correctly, it began to work correctly
