Part Number: BQ25713B Hi,
My customer report an issue that it does not charge when the input is connected.
I have asked for their regs readback as below. Quickly check then I see the charge_inhibit bit is set.
Customer tell they have not set this…
Part Number: BQ25713B Other Parts Discussed in Thread: TIGER , BQ25730 , BQ25731 Hi,
Our design uses a BQ25713B with an adapter input voltage of 24Volts. In PTM mode both highside switches are open and the 24V are passed through to VSYS.
The datasheet…
Part Number: BQ25713B Other Parts Discussed in Thread: BQ25713 Hi,
My customer wants to know if they can config the BQ device for re-activation of the over discharge battery.
When the battery is over discharged(0V), it will need 6.6V to reactivate…
Part Number: BQ25713B Other Parts Discussed in Thread: BQ25713 , BQ25720 , BQ25723 , BQ24190 Hello TI Support Team,
As per our technical requirement charging IC BQ25713B is suitable so i want to simulate the same. So required PSpice simulation model…
Part Number: BQ25713B Other Parts Discussed in Thread: BQ25713 Hello team,
I have a question regarding the CHRG_OK.
I'm trying to design an MPPT charger, so my input comes from a PV panel. During night-time, CHRG_OK pin goes LOW which is normal and…
Hi Di Ma,
I think there is some misunderstanding here, user should set up a correct value to CELL_BATEPRESZ pin based on cell count, Pulling it low will tell charger there is no battery connected(or battery is removed). This pin can only set the cell…
Part Number: BQ25713B Hi
My custom design the schematic of BQ25713B and find the BTST1-SW1 is 8.28V
Attached the waveform
It is out of SPEC, What effect and how to improve?
Thanks
Star
Part Number: BQ25713B Other Parts Discussed in Thread: BQ24172
Hi
The customer design the schematic and charge normal.
But when the battery near full the charger went into plus charge, charge current jump from 250mA~0mA~250mA~0mA
The battery is…
