Part Number: BQ25758 Other Parts Discussed in Thread: , BQ25756 Hello, the description of TS/NC pin in datasheet states: "To enable pin functionality, set EN_TS register bit to 1". But in register description there is no EN_TS pin.
My question is will…
Part Number: BQ25758 Tool/software: HI Sir,
BQ25758 pass inductor L1 "Table 7-1. Recommended Part Numbers for up-to 48-V EPR (5-A output): (continued)" show CMLB135T-100MS value: 10 μH, 22 mΩ, 10.5~13A
if i use 19.5V/15A input, is still can use the…
Part Number: BQ25758S Other Parts Discussed in Thread: BQ25758 , TPS25751 , TPS25730 Tool/software: Hi TI,
We are designing single cell battery chargers and there will be a total of 20 battery charging ICs in parallel with 0.5A output. We would like…
Part Number: BQ25758 Hi,
I have a battery charger design using the BQ25758. I can accurately set the converter output voltage using REG0x04_Output_Voltage_Limit register but when I read back the voltage using REG0x33_VOUT_ADC I am getting a reading…
Part Number: BQ25758 The BQ25758 is a nice fancy part and it has both the input and output overcurrents.
On both sides (input & output), what is the overcurrent based on? Instantenous hardware comparator catching the peak? Internal software timer?
Part Number: BQ25758 Other Parts Discussed in Thread: BQ25756 , Tool/software: Hi team,
Customer ask what is the difference between BQ25756 and BQ25758,
Can you show the key differences of these two devices?
Is BQ25758 only can work with 14 cells…
Part Number: BQ25758 Other Parts Discussed in Thread: BQ25756 , TPS25751 , , TPS55289 Tool/software: When trying to configure the TPS25751 with the USBCPD application customization tool, the BQ25756 is presented as one of the battery chargers. I do not…
Part Number: BQ25758 I have the BQ25758 where I have a 133kOhm resistor pull down on the FW_SYNC pin to default to 250kHz operation.
At the same time, I have a 250kHz waveform feeding into the pin from a clock generator. The intention is to operate…
Part Number: BQ25758 Tool/software: Hi,
Recently I have started using BQ25758 which is available in Thunderbolt design, and configured IOUT_REG to trigger OCP at 1A current by programming IOUT_REG with value 0x0050.
When OCP occurs, I see that the…
