Part Number: BQ25886 Tool/software: Hello：
The customer is currently using TI's BQ25886 charging management IC, and there has been an incident of the BAT pin of BQ25886 burning out during the production process. As shown in the following figure
…
Part Number: BQ25886 Tool/software: Hi all,
My customer is considering using the BQ25886 without battery.
When the VSYS and VBAT pins are shorted, it can work boost converter that outputs voltage from 5 V to 8.4V.
Is it possible to use this method…
Part Number: BQ25886
Tool/software:
Dear TI Support Team,
I am currently encountering an issue with the bq25886 charger IC. The charging voltage is configured to 8.2V, but as the battery voltage approaches 8.0V, the charging current starts to drop…
Part Number: BQ25886 Other Parts Discussed in Thread: BQ25883 Tool/software: Hi, TI expert
We have an enquiry from a customer regarding BQ25886. Is it possible to distinguish the status of charging and complete charging only by the status pin?
The…
Part Number: BQ25886 Tool/software: Hi Team,
This is my overall block diagram.
The issue is, I'm trying to power the load from power bank without battery. In this case, current is input current is limited to 500mA.
I have placed 0ohm resistor…
Part Number: BQ25886 Tool/software: Dears,
help to check schematic diagram.
input and output is ok under 8.4v.
question is it just can charge by 100mA current.
Part Number: BQ25886 Hi, TI expert
A customer is considering the BQ25886 and has a few questions.
Looking at the datasheet of BQ25886, it appears that BC1.2 is supported.
According to the document, if the input is 5V and the charging current is…
Part Number: BQ25886 Other Parts Discussed in Thread: BQSTUDIO
Tool/software:
Hello,
I have designed a 2S/2A battery charger using the BQ25886 IC with a 5V input supply. A 7.5 kΩ resistor is connected from the ICHGSET pin to GND to set the charge…
