Hi Dominik，
Sorry, I still don't understand your response.
1、Regarding the update conditions for the AVG I/P LAST RUN register: After the discharge lasts for more than 500 seconds, will the register be updated during the discharge or after the discharge…
Part Number: BQ27426 Tool/software: Hi,
My customer encountered a problem when using BQ27426.
RD set terminate voltage at 3.3V. Terminate voltage is system shutdown voltage, and also the RSOC 0% relative voltage.
But now when the discharge reaches 3.3V…
Part Number: BQ27426
Tool/software:
Hey, I have a problem that the used gauge is not updating the state of charge after soft reset.
Following code is how i config the gauge now: retval BQ27426::InitModule()
{
CHECK_RV(i2c_master_.Probe(kI2cAddress…
Part Number: BQ27426 Tool/software: Hi expert,
We are having a burn problem, isn't this a firmware burn to ROM?
Why is the updated firmware gone after reseating the battery, changing back to the chip factory default firmware parameters. Does BQ27426…
Part Number: BQ27426 Other Parts Discussed in Thread: BQ27427 Tool/software: Hi All,
I have a question about the BQ27426.
Is the BQ27426 a voltage monitoring product? I think it is a current monitoring product. Which is it? If the BQ27426 is a current…
Part Number: BQ27426 Tool/software: Hi team,
My customer is evaluating the system power consumption for battery system.
Could you help to provide the maximum quiescent current of BQ27426? There is only typical value in datasheet.
Regards,
Ben
Hello Marco, The R sense resistor is used to gauge the flow of current within a system through having a know resistance and being able to determine voltage coming in and out of the resistor. SDA and SCL shouldn't pull below ground since all the ground from…
Part Number: BQ27426 Tool/software: Hello TI Team,
We are planning to implement the BQ27426YZFR fuel gauge IC in our product, but we are facing challenges in PCB routing, particularly for the VSS (ground) pin , which is located at the center of the 9…
Part Number: BQ27426 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hi,
My customer is developing using BQ27426.
Do we have “Battery management studio (bqstudio) 1.3.127” user guide?
BR,
Zach
Part Number: BQ27426 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hi expert,
I found that when BQ27426 was configured with a different chemical ID, the following screen was automatically changed to the configuration value, which is reasonable…
