Hi,
Tarek Sharbo said: → Is this expected behavior after turning off IT tracking?
yes
Tarek Sharbo said: Once the learning cycle is marked complete ( Update Status = 0x06 ), should the gauge handle FET control automatically?
no, the fets are controlled…
Part Number: BQ40Z50-DEVICE-FW Tool/software: Hi Ti Team，
When we use BQ40Z50-R3 FW VERSION 3.09 and continuously charge the battery to the end of charging with SOC = 99%, after the NCT flag in the charging state is set to 1, if there is a discharge…
Part Number: BQ34Z100-DEVICE-FW Other Parts Discussed in Thread: EV2400 Tool/software: I'm downloaded the latest version of the bq studio it is not deducting my fuel gauge ic it showing only none
Hello Miguel,
Thank you for your detailed analysis. As you showed in the graph, it appears my EDV2 point is not stable. While waiting for your response, I had a few more attempts. After sending the data following my tests for Chem ID selection, I was…
Part Number: BQ40Z50-DEVICE-FW Other Parts Discussed in Thread: BQ40Z50 Tool/software: Hi TI team,
Currently, the Firmware Version of BQ40Z50-R3 is 3.09. What is the current improved Firmware Version of BQ40Z50-R3? Could you provide the relevant information…
Part Number: BQ78350-DEVICE-FW Other Parts Discussed in Thread: BQ78350 Tool/software: Hello,
Until now I have worked with the bq78350_R2. Now I have switched to the R3 version to use the balancing at rest, but it does not work.
In the post
https…
Part Number: BQ78350-DEVICE-FW Tool/software: Hi E2E,
I am trying to download the BQ78350-R2-FW from the link below.
www.ti.com/.../R2-V2.02
But the download page shows 'Error 404'."
Please assist me in obtaining the "BQ78350-R2-FW".
Thanks…
Part Number: BQ28Z610-DEVICE-FW Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hi Alan and TI support team,
I’ve successfully performed the ChemID setup on a new board, and everything was proceeding smoothly during the learning cycle. I configured…
Part Number: BQ78350-DEVICE-FW Other Parts Discussed in Thread: BQSTUDIO , BQ78350 Tool/software: Hello!
I have a problem with cell balancing at rest with bq78350R3. I have a 15S LiFePO4 battery where cell balacing at rest is necessary. * bqz Device…
Hi Alan,
Thank you so much for your reply and for sharing the links.
In the GPC report I received, the recommended ChemID (with the lowest deviation) wasn’t available in the chemistry list, as you mentioned. However, the report also included a list…
