Part Number: BQ34210-Q1 Other Parts Discussed in Thread: GPCCEDV Tool/software: Hello Team,
I am currently investigating a battery management system using the bq34210.
We want the RemCap value to become 0 when the final voltage reaches 3000mV, but…
Part Number: BQ34210-Q1 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hello team,
We are using battery gauge IC part- BQ34210IPWRQ1 in our design with BQ24105IRHLRQ1 battery charger to charge a Lithium polymer battery having rating 1000mAh…
Part Number: BQ34210-Q1 Tool/software: Hello Team,
I am using this document for performing learning cycle->
https://www.ti.com/lit/an/slua903/slua903.pdf?ts=1741788480031&ref_url=https%253A%252F%252Fwww.ti.com%252Fsitesearch%252Fen-us%252Fdocs%252Funiversalsearch…
Part Number: BQ34210-Q1 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hello Team,
We have a custom module where we are using BQ34210-q1 fuel gauge. But we are able to set Design Capacity range. But when we tried to set Full charge Capacity…
Part Number: BQ34210-Q1 Other Parts Discussed in Thread: BQSTUDIO , EV2400 , , GPCCHEM Tool/software: Hello Team,
I am not able to connect the Battery Gauge IC on my PCBA with BQSTUDIO tool.
When the Battery Gauge IC is connected to Host SOC- I2C…
Part Number: BQ34210-Q1 Hi
I have a query need your help.
1.I have encountered some problems, the manual says that you should use little endian write command, but the configuration given in the manual section 7.1 is big endian, which one should I…
Part Number: BQ34210-Q1 Tool/software: Hello Team,
We have a custom module where have used BQ34210IPWRQ1 fuel gauge.
MCU and fuel gauge are connected through I2C lines. And we are able to read some basic readings like reading device ID, reading remaining…
Part Number: BQ34210-Q1 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hello Team,
We have a custom module where we are using BQ34210-q1 fuel gauge. But we are able to set Design Capacity range. But when we tried to set Full charge Capacity…
Part Number: BQ34210-Q1 Other Parts Discussed in Thread: BQSTUDIO , , EV2400 Tool/software: Hello Team,
I have Started Learning cycle
But when I read the EOSLearnStatus() register continuously in loop I was able to see that LUCD and LFAULT flags…
Part Number: BQ34210-Q1 Hello,
I have read sluube8, but I don't know how to set "WK_TH1" and "WK_TH2" in "Operation Config A Register Bit". It says to check (SLUSCG1) for the threshold, but even after checking (SLUSCG1), I can't find the threshold.…
