Part Number: BQ35100 Hi all,
We need help to configure BQ35100. We have having ER34615 battery pack containing 4 cells in parallel. In parallel to these batteries, we have an 80F lithium capacitor. We are unable to set the battery capacity to 76000mAh…
Part Number: BQ35100
Tool/software:
Current Technical Reference Manual 3.1 Obtain Raw Calibration Data indicates that calibration mode should be entered and exited during this sequence...This Wrong. If calibration mode is exited at the time indicated…
Part Number: BQ35100 Tool/software: BQ35100 is tested in EOS mode, with the following configuration: New Batt R scale delay : 0x02 EOS_TREND_DETECTION_PERCENTAGE : 0x14 EOS_DETECTION_PULSE_COUNT_THRSHD : 0x78 CELL DESIGN CAPACITY : 1200 mAh CHEM_ID :…
Part Number: BQ35100
Tool/software:
Hello, I just want to confirm the following for ACC mode: The Counter does not function when GE is OFF-Correct? The Coulumb Counter starts and continues counting When GE is ON? It doesn't matter if gauge_start/stop…
Part Number: BQ35100 Tool/software: BQ35100 is tested in EOS mode, with the following configuration: New Batt R scale delay : 0x02 EOS_TREND_DETECTION_PERCENTAGE : 0x14 EOS_DETECTION_PULSE_COUNT_THRSHD : 0x78 CELL DESIGN CAPACITY : 1200 mAh CHEM_ID :…
Part Number: BQ35100 Tool/software: Hello going through and setting up a device for my battery-pack configuration here's what I have: Battery jut uses utilizes parrallel cells. data memory -> gas gauging: cell design capacity mAh = cell_rate_capacity…
Part Number: BQ35100 Tool/software: I know that the battery is not supposed to be disconnected, and if it is you are supposed to hit NEW_BATTERY. However, for completeness' sake, what would be the best procedure to follow if the battery were unplugged…
Part Number: BQ35100 Other Parts Discussed in Thread: BQSTUDIO Tool/software: So in the docs for EOS mode it states that you need to run gauge start before each power pulse. However, the gauge doesn’t seem to read anything at all in bqstudio until I run…
Part Number: BQ35100 Tool/software: Dear TI Support, I'm developing a custom board using BQ35100 device. My goal is to monitor a custom battery pack with 2 D-cells in parallel with a lithium battery also in parallel (due to the peak current needed by…
Part Number: BQ35100 Tool/software: We have custom hardware with bq35100 installed. Current hardware unfortunately does NOT support open open circuit voltage calibration. 1)Can I calibrate voltage with current flowing? What are the effects? I may be able…
