Part Number: BQ35100 Tool/software: Hello,
Can I read the SOH value during normal system operation (with a load attached)? I am asking because this has an impact on the SOH accuracy, which is worse with bigger loads.
Yesterday, my battery SOH was…
Part Number: BQ35100 Hi Team, My customer considers EOS mode for Li-SOCl2 battery (LSH20). Regarding my customer's application, it could be the case the battery is removed then inserted the same battery. It means the power supply of BQ35100 is lost in…
Part Number: BQ35100 Tool/software: Hi Dear TI experts,
I have trouble setting security mode from full access to unseald mode (required for reading data flash), below is the code
#define SEAL_CODES_DEFAULT 0x 04143672
data [ 2 ] = ( char…
Part Number: BQ35100 Tool/software: HI team,
Could you answer to the following questions?
1. SOH and EOS needs CHEM ID, but ACC doesn't. Is it correct?
2. Is it able to add new CHEM ID of Li primary battery SB-C02 by Vitzrocell? How long do you…
Part Number: BQ35100 Tool/software: I am currently developing a humidity sensor-based wireless sensor node powered by a primary battery, either lithium thionyl chloride (LiSOCl₂) or lithium manganese dioxide (LiMnO₂). The objective is to operate the sensor…
Part Number: BQ35100
Tool/software:
Dear TI-Team,
i want to use the BQ35100 for gauging an Li-SOCl2 Battery. In Section "10 Layout" of the Datasheet of the BQ35100 under point "10.2.1 Ground System" is an ideal Ground System for the system Grounds…
Part Number: BQ35100 My application contains a primary battery pack, consisting of 6 PARALLEL CELLS of Li-SoCl2 battery.
I want to monitor the battery pack and understand a while before that the pack is reaching it's end-of service.
As such, I need…
Part Number: BQ35100 Tool/software: Hi,
I have a product using the BQ35100 that's in design verification stage at the moment. We realized that there was a mistake made in the design where the I2C IOs were being driven at 1.8V whereas the VCC for the…
Part Number: BQ35100 Hi sir,
In our current design , we are using "BQ35100PW" battery monitor IC ,interface with STM32L5 controller using I2C .
Currently we are checking the battery charge( LiSOCL2 primary battery cell used for power) in accumulator…
Part Number: BQ35100 Other Parts Discussed in Thread: GPCCHEM Hello,
we want to use a BQ35100 (EOS-Mode) in our system to monitor our LTCs, which are FANSO ER18505M.
This battery is currently not characterized, so I cannot choose it in the Chem-ID…
