Part Number: BQ40Z60 Hi TI Team,
We are using BQ40Z60 and 2 cells of Panasonic NCR18650B battery in series.
As specified in NCR18650B datasheet, the charging voltage should be 4.2+/-0.03V.
The output ripple & noise of the charger is 240mV max. The measured…
Part Number: BQ40Z60 Other Parts Discussed in Thread: BQSTUDIO Hello
I am working on the BQ40z60 EVM. I am able to manually charge and discharge the cell. But I am still not able to configure the charging current and make it as a standalone system. Could…
Part Number: BQ40Z60 Hi e2e community,
Thanks for your help so far. We've been able to modify an EVM board to our specific needs and have based our current schematic on that. One question that remains is if it is best practice to pull unused pins fr…
Hi Damian and others, I accidentally marked your reply as having solved my issue, instead of not solving. So to clarify, the issue is still present. Thanks again
Part Number: BQ40Z60 I have a problem with the bq40z60.
If I put the load( e.g. 500mA) to the vsys point on the refference schematic, the charging current will be 500mA ( charging current preset==1000mA).
If the load current increasing (e.g. 1500mA),…
Part Number: BQ40Z60 Hi,
In our current application, We don't have much time to let the system to get valid OCV reading because the system has to be ready whenever it needed. Once the battery already got one regular QMAX update (not from fast QMAX…
Part Number: BQ40Z60
Hi TI Team,
We are using BQ40Z60 and 2 cells of Panasonic NCR18650B battery in series.
When the battery is fully charged, RSOC reaches 100%. If I leave the charger connected for a few days, I notice RSOC can be dropped to about 95…
Part Number: BQ40Z60 I found it at BQ40Z60 technical reference manual at shutdown mode section :
NOTE: The device goes through a full reset when exiting from SHUTDOWN mode, which means the device will re-initialize. On power up, the gauge will check some…
