Part Number: BQ756506-Q1
Tool/software:
I'm using the following steps to read cell voltages from the BQ756506 via UART:
Able to read only part ID, but not able to read voltage , current and temperature. I've attached the TX pin waveform from…
Part Number: BQ756506-Q1 Tool/software:
I’m working with the BQ756506-Q1 using UART communication and encountering an issue when trying to read data after sending the wake-up command.
cmd : 0x80,0x00,0x05,0x00,0x00,0x35,0xDF
Is there a specific…
Part Number: BQ756506-Q1 Hi Team
Have a good day!
we will working on BQ756506-Q1.
If there is any reference design/sample schematic? please help provide if possible.
Part Number: BQ756506-Q1 Tool/software: I am only able to read default values instead of actual cell voltage, current, and temperature data.
Issue Observed: - The device responds, but all cell voltage, current, and temperature readings remain at default…
Part Number: BQ756506-Q1 Tool/software: Hi
I'm facing an issue where NFAULT pin is always Low even when NFAULT_EN bit in DEV_CONF register is cleared.
Does anyone have a clue for me?
RB,
Viet
Part Number: BQ756506-Q1 Hello experts,
We are using BQ756506-Q1 in our project. I have some doubts and need your help:
1、UART pull up resistor: If we don't pull TX/RX up , what will happen? Can the UART communication work normally?
2、 What can…
Part Number: BQ756506-Q1 Tool/software: Hello All ,
I am searching for a simple passive charge-balancing IC for the 4S2P 26650 (3.3V, 2.6Ah) configuration. I wanted to know if overcharge detection voltage, overcharge release voltage, cell-balance detection…
Part Number: BQ756506-Q1 Hello experts,
I am using BQ756506-Q1 and I need your help:
1、I use BQ to measure cell and PABA temperature, 7GPIOs used to measure 7 channels temperature totally. I want to know how long if we want to finish 7 temperatures…
Part Number: BQ756506-Q1 Hello TI Team,
A question about the DS parameter "VACC_MAIN_CS" it says ADC accuracy for current sense is 1.1mV.
If I use a 100uOhm shunt, means the accuracy is 10A, is that correct?
How can I calculate the total accuracy…
