Part Number: BQ76922 Other Parts Discussed in Thread: BQSTUDIO Tool/software: May I get the .BQZ file for the BQ76922 monitor please as I dont want to use evaluation software. If dont have is that means that this BQ76922 model is not available for BQStudio…
Part Number: BQ76922 Hello Experts,
I have used Commands, Subcommands and also accessed Data Memory so far and the read Values are correct mostly.
One Exception I have noticed are the SEC0-1 Bits of Battery Status Register. They both always return…
Part Number: BQ76922 Tool/software: Hello,
Would it be possible to draw 400uA off the REG18 integrated linear regulator?
IC max draw on REG18?
Thank you, Keith
Part Number: BQ76922 Tool/software: After performing OTP the device is installed to the battery pack. After installing I am getting the output but it is not entering to Sleep mode even though the SLEEP_EN bit is high. What may be the cause
Part Number: BQ76922 Hi Experts,
Whether we have the test reports of BQ76922 short circuit under shutdown→wake up?
The customer is concerned the externa CHG/DSG mosfet will be damaged.
Part Number: BQ76922 Tool/software: Hi Guys,
why is there no reply to my question ? ( original question link )
Have i been blacklisted ? (or) is there any problem with the BQ76922 support team ?
kindly let me know and do review my schematic. I'm…
Part Number: BQ76922 Tool/software: Hello,
We are designing with the bq76922 and have some questions on the Fuse functionality.
The intended operation is for the FUSE pin to drive the gate of a low-side NMOS. The Logic NMOS would then drive a high…
Part Number: BQ76922 Tool/software: Hello,
I can make DFETOFF/CFETOFF as an open drain output. It looks like it? Just want to confirm!
Also, another question is how quickly the I/O can be driven high and low, would we have the 250ms delay? Or could…
Part Number: BQ76922 Other Parts Discussed in Thread: BQSTUDIO Tool/software: I am trying to calibrate the current in BQstudio (Current Gain Calibration).
It works, but when I power cycle the product the value is not saved (some large figure is displayed…
