Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: BQ76PL536A-Q1 Tool/software:
I am only using the SPI comms to host for the faults and alerts? What do I do with the unused pins for noise and power consumption? Should they be left floating?
Part Number: BQ76PL536A-Q1 Hey TI team,
I am observing a rare issue in where CELL_UV/CELL_OV FAULT registers in this ASIC are asserted on bootup. I have some suspicion that there is an unstable Vref and was wondering if you could provide more details on…
Part Number: BQ76PL536A-Q1 I am working on a BMS application and i am using the BQ76PL536A-Q1 for reading cell voltages. Firstly, i want to program it with nucleo-g474re microcontroller. Which are the steps that i have to follow? Is the 7V pulse in LDOD…
Part Number: BQ76PL536A-Q1 I am working on a bms application. I have a nucleo-g474re microcontroller and the BQ76PL536A-Q1. How can i set the address in the BQ and then program it by eprom registers, using the microcontroller? Or should i make something…
Part Number: BQ76PL536A-Q1 i am currently working on an automotive bms (proprietary) using one single bq76pl536A-q1 (so no north or south facing chips) I have confirmed that the Gates of the balancing-Resistor-driver-FETs are connected to the balancing…
Hi Geoff-san, When applying only to BQ76PL536A-Q1 alone, what is the minimum voltage that should be applied to which terminal? (To check the hot point). Regards, Kagawa
Part Number: BQ76PL536A-Q1 1. If you experience an abnormal symptom that AD conversion does not complete within the specified time, please let us know if there are any possible causes. If there is a possible cause, does it recover normally by POR (Power…
Part Number: BQ76PL536A-Q1 Other Parts Discussed in Thread: BQ76PL536EVM-3 , Hi Everyone
Im used a custom PCB based on BQ76PL536EVM-3 board, so the connections and SPI communications are fine.
Im using 2 BQ76PL536A-Q1 in daisy chain configuration (a microcontroller…
Hi Zeeshan,
Please understand that we do not typically answer E2E questions on weekends. If you ask a question over the weekend, we will make sure that we answer it the following Monday (CST).
You do need to use the SDO_H, SDI_H, SCLK_H, and CS_H pins…
