Part Number: BQ77207 Hi Team,
There is a good new that we could DIN TI product!
Customer is looking for the replacement of ADA4432-1WBRJZ-R7
https://www.mouser.tw/datasheet/2/609/ADA4432-1_4433-1-878278.pdf
Please help suggest TI solution, THX
Part Number: BQ40Z50-R2 Other Parts Discussed in Thread: BQ40Z50 , BQ77207 Hi,
Can the BQ40Z50 BMS IC be configured to use PTC resistors for TS1 / TS2 / TS3 / TS4 instead of NTC resistors?
Best regards,
Joe DeWitt
Hi Jason, BQ77216 — 3s to 16s:
Voltage and temperature (NTC) based protection features, has two fault outputs which are typically used to drive a chemical FUSE.
BQ77207 — 3s to 7s:
Voltage and temperature (NTC or PTC) based protection features…
Part Number: BQ77915 Other Parts Discussed in Thread: BQ2970 , BQ77905 , BQ77216 , BQ7718 , BQ77207 Hi team.
What's hte difference between primary protector and secondary protector? Thanks!
Nison
Hi,
Since the BQ2961 has only the active high output configuration, it is not likely to control back to back FET in place of the FUSE.
To have back to back FET control option, BQ77207 might be an option. You can use active low output config option to…
Hi Matt,
Appreciate your help. In my case, I am using the BQ7692006PWR. Does that have a similar requirement of not shorting V16? I only have 5 cells, so does that make sense to short V4-V15? I also considered the BQ77207, but the voltage range was too…
Other Parts Discussed in Thread: BQ77207 Hi Sir,
My customer would like design 4 pcs 18650 battery in series.
as you know, 18650 battery not embedded PCM(protection circuit module)
Would you please provide recommendation for this protection IC?
is BQ…
Part Number: BQ7718 Other Parts Discussed in Thread: BQ77216 , , BQ77207 Hi,
my customer is looking for a device / solution similar to BQ771824 but with an OVP = 3.8V threshold.
Is there anything we can recommend?
BR Josef
I just have one more question Matt, I was looking for a suitable fuse that could be triggered by the BQ77207, I was even looking through TI parts and their eFuse devices, I couldn't find one that is rated for an above amperage of MAX 10A with the volt…