Part Number: BQ76952 Other Parts Discussed in Thread: BQSTUDIO Hi,
I'm using BQStudio Test build 1.3.124.
I want to export a Data Memory configuration for later. However I have noticed that when I re-import the config file I just exported one of…
Part Number: BQ40Z50-R2 Other Parts Discussed in Thread: BQSTUDIO Hi
I have very simple question for BQ40Z50R2 calibration with bqStudio GUI.
We will do calibration by bqStudio , but I want to confirm this bqStudio GUI .
Because of this is bqStudio…
Other Parts Discussed in Thread: BQSTUDIO , BQ27510-G3 , BQEVSW Refer to sluua97 page 35 which describes Op Config register. Bit locations labeled GPOUT_POL, GROUP_INT and BAT_FN have different names in the bqstudio GUI where they are called SOCI_POL…
Hi Freidoon,
Can you please provide an updated capture of the BQStudio GUI menu with 10V and battery connected after clicking read registers? Can you verify if NTC Fault has changed from Hot to normal with the jumper change?
Best Regards,
Garre…
Part Number: BQ78Z100 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hi team,
May I know if BQ78z100 support FS burning file in BQstudio GUI, customer can only read srec file
BR
Amber
Part Number: BQ27427 Other Parts Discussed in Thread: BQSTUDIO Hi, We are calibrating the BQ27427 fuel gauge, so we need to read the average values for Pack V Offset, CC Offset, CC Gain, and CC Delta. However, these parameters are not listed in the Data…
Part Number: BQ76922 Other Parts Discussed in Thread: BQSTUDIO Tool/software: May I get the .BQZ file for the BQ76922 monitor please as I dont want to use evaluation software. If dont have is that means that this BQ76922 model is not available for BQStudio…
Hi Christian,
Once again, thank you so much for that link, we are moving forward rather well now.
One thing we don't understand now, the Register Addresses shown in the GUI are quite different than the datasheet values. Perhaps you can help us understand…
Hello Gilberto,
Yes you can do testing with the EVM without the EV2400. The EV2400 is used with our BQStudio GUI to easily configure the charger, but it is not required for testing.
Sincerely,
Wyatt Keller
Hello, We stopped doing maintenance in bqEVSW GUI. The support is very limited when customer are using this tool. The people who used to work in these tools are not in the team anymore. If it is a SMBus reading issue, I would start by checking why there…
