Part Number: CC1101 Tool/software: I know that this has been asked before and answered before but I have to ask using a specific part.
I have an immediate need to use a pre-made 433MHz FOB with a CC1101 receiver.
OTX-433-HH-KF2-MS
www.te.com/.../DDE…
Hi Diego,
Sorry but your response does not resolve the issue. Following the initial request:
Wanting to optimize the register values by taking an RX BW of 270 kHz as a reference, I followed the following steps: - select the preset with RX BW >= 270: 3…
Part Number: CC1101 Tool/software: Hello siri,
We are trying to use the CC1101 in WOR & using the address filtering while receiving the packet in WOR mode. So if the address is mismatch of the received packet then the CC1101 drop the packet but it gets…
Part Number: CC1101 Tool/software: Hi, community
I bought two CC1101 modules of Ashining for testing purpose, then I connected them to CC Debugger, the LED is green, so I assume the connection is good.
By opening the SmartRF Studio, I can see them appear…
Part Number: CC1101 Tool/software: Hi,
I need support for 315 MHz and 434 MHz on the same pcb with the same bom. They are not needed concurrently.
In the post https://e2e.ti.com/support/wireless-connectivity/sub-1-ghz-group/sub-1-ghz/f/sub-1-ghz-forum…
Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC1101 Hello E2E community,
I'm encountering an issue with communication between CC1101-Q1 and CC1101 modules, and I'm seeking assistance to troubleshoot and resolve it.
Background: I recently…
Hi TI-CSC,
As far as I understand, Pin 2 is just there for sensing the Vdd voltage. I believe you should also connect Pin 9 to Pin 2, and the CC1101 Vdd.
Regards,
Arthur
I am sorry, but I do not know how to help you. As I said before, you have previously had the WoR up an running, now your TX seems to be fixed, and you should be able to get WoR up and running again since you have already managed this before.
I have no…
Hey, community,
I have been eagerly awaiting some replies to this post. In case there is any confusion caused by the Chinese characters in the attached images, here are some notes:
Explanation of the Oscilloscope Images:
In the attached oscilloscope images…
Part Number: CC1101 Other Parts Discussed in Thread: CC1310 , LAUNCHXL-CC1310
Hi, I'm trying to communicate a LAUNCHXL-CC1310 board with a custom board which uses a CC1101. I'm using the custom board on a proyect based on MPLAB, on the other hand I…