Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC1101 While the CC1101 datasheet offers circuit design references for individual frequency bands, it lacks reference designs for dual-frequency circuits.
Is there any way to do this ? any suggestions…
Part Number: CC1101-Q1 Tx-If-CCA,
Hi is that setting required for FCC compliance.
I understand that the registers in the application notes may have been using this setting.?
We however would like to potentially develop a Tx only version that once configured…
Part Number: CC1101-Q1 64 IDLE 0 64 OK 65 IDLE 0 65 OK APPEND_STATUS = 1 CRC_EN = 1 66 RX 0 65 - FEC_EN = 0 67 RX 0 65 - 68 RXFIFO_OVERFIEW 1 65 OK
for the cc1101-q1 silicon errata and following setting
Does it mean that for variable packet lenght…
Hi,
The ESD protection needs to be positioned between the antenna / RF signal and the GND. It will not work with replacing the DC blocking cap with the ESD protection.
Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC1101 Hello Forum,
I am using TI's CC1101 module with EFM32GG11 giant gecko EVM kit. I can read and write the SPI registers of CC1101 but not able to transmit data over RF (transmit strobe is not…
Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC-DEBUGGER Hi,
Good Day.
Is it possible to connect a CC-DEBUGGER directly to a CC1101-Q1 device or does it need to be on an evaluation board? or does it need to be on an evaluation board?
Please…
Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC1101 ,
Hi,
We have a situation where the device has entered some mode from which it cannot recover without a full reset/hard reset.
When this happens we can observe following.
Device still communicates…
Part Number: CC1131-Q1 Other Parts Discussed in Thread: CC1101-Q1 , , CC1101 team,
Automotive Customer is asking about CC1131-Q1 EVM and CC1101-Q1 EVM.
They are no longer available. Who they could contact to get more information about these devices and…
Part Number: CC1101-Q1 Other Parts Discussed in Thread: CC1101 , SMARTRFTRXEBK , CC-DEBUGGER Hi Experts, Good day I am having an issue with SmartRF Studio 7. When connecting to a CC1101-Q1 device I get a warning saying communication error relating to chip…