Search tips
Showing 103 results View by: Thread Post Sort by

  • SMARTRFTRXEBK: SmartRF Studio 7

    TI Thinks Resolved
    Part Number: SMARTRFTRXEBK Other Parts Discussed in Thread: CC1101 , CC110L , CC115L Can SmartRF Studio 7 be run under Windows 10, I have been using Windows XP successfully...

  • CC115L: Not able to get proper data by transmitter

    Part Number: CC115L Other Parts Discussed in Thread: CC1101 Dear TI E2E Team, I am not getting proper data by transmitter. I followed these steps. 1. CS=LOW, Initialize the register in brust mode, Not used register written = 0x00, reserved and register…

  • CC115L GDO2 configuration

    Hello, I would like to verify that I understand the CC115L datasheet correct. On page 38 under "Table 5-12. GDOx Signal Selection (x = 0, 1, or 2)" in last row: "(0x2F) HW to 0 (HW1 achieved by setting GDOx_INV=1). Can be used to control an…

  • CC115L current consumption influenced by environment?

    Other Parts Discussed in Thread: CC115L Hi, a customer of mine struggles with current consumption of CC115L at final production test. Is it possible that the environment at the production test site influences e.g. the radio PA such that a current consumption…

  • CC115L GDO0 power-up

    Other Parts Discussed in Thread: CC115L , CC110L Hello, We are using the CC115L without any interrupts driven. When tested upon power-up the GDO0 and GDO2 are active for a few uSec. What should be done for production? Should we terminate the Pin 3,6 (GDO0…

  • CC115L Pocsag implementation

    Other Parts Discussed in Thread: CC115L , CC1101 Hi, I am trying to implement pocsag protocol using CC115L to connect to pager (apollo AL-901L). In SmartRF studio I set Base frequency = 432.999817 MHz, Deviation: 4.760742 kHz, Data rate = 2.39897 kBaud …
    • Answered

  • cc115L RF interference

    Resolved
    Other Parts Discussed in Thread: CC115L Hi, We have a design based on CC115L which creates some type of RF interference in frequencies above the main carrier. This interference is seen only when we transmit above -15dBm, when we use lower power it disappears…
    • Resolved
    • Answered

  • CC115L send unmodulate wave

    Resolved
    Other Parts Discussed in Thread: CC115L Hi, I want use MCU to confige CC115L to send unmodeled wave ,and use it to measure TX power. I don't know exactly what's the procedure to do it. I have successful use CC115L to send modulated data ,but i don…
    • Resolved
    • Answered

  • When the CC115L has clock failed.

    Resolved
    Other Parts Discussed in Thread: CC115L Hi everyone, I want to know the behavior of CC115L. When this device has clock failed during IDLE state, is there a possibility that the current flows from XOSC_Q2 pin? For example, when XOSC_Q2 is short to GND,…
    • Resolved

  • CC115L Reference design for 4 Layer board

    Other Parts Discussed in Thread: CC115L , CC1190 Hi all, Is there a reference design for 4 layer board for CC115L? I like to see how the impedance is controlled for the antenna section and would like a stack up that I can reference also. Does anyone have…

Didn't find what you are looking for? Post a new question.