Part Number: CC2541 Hello,
I am using the smartRF studio 7 for test CC2541. plan to use this APP to control C2541 to send RF signal to the test device.
I use SMA cable to replace the antenna, in order to connect to test device. the SMA cable connect to…
Part Number: CC2541 Other Parts Discussed in Thread: CC2650 ,
We are in the process of developing a product centered around the Bluetooth 5.0 protocol, and as such, we require a BLE remote control reference design along with its corresponding…
Part Number: CC2541 What is the time it takes for the 8051 core to be available for commands, that is, the MCU reset/shutdown to active? This is for comparison with the CC2340Rx -- table 8.18.2, wakeup timing.
Thank you!
May I ask how to operate the HCI testing mentioned in the document?
Guillaume said: You'll have all the informations concerning Bluetooth certification in the dedicated app note below:
https://www.ti.com/lit/an/swra601/swra601.pdf
Part Number: CC2541 I have a custom cc2541 flex PCB (5 pieces) that I fabricated in one of the major fab houses.
As soon as I received them, I hooked one up to the CC Debugger and the red light went off, the board got hot, and I suspect I fried a bunch…
Part Number: CC2541 We Used the CC2541 Bluetooth Chip in our product.
We already make a product with CC2541.
And we want to test the cc2541 chip with SmartRFtm Studio 7 V2.17.0
And we select the 2.4GHz CC2541 BLE mode.
And connect the device product but…
Hi,
No worries! I hope you had a good vacation! If no OAD occurred, then unless there are other sections of code that write to the flash, I am not sure what else could cause the BIM to change. Is it possible there are environmental factors here at play…
Hi,
The approach followed is not standard and has not be thoroughly tested on our side. In addition, we recommend to use P1_1 as PA pin as it has 20-mA drive capability.
Please refer to the CC254x User's Guide ( https://www.ti.com/lit/swru191 ), part…
Part Number: CC2340R5 Other Parts Discussed in Thread: CC2541 Hello colleagues,
I have a customer who wants to migrate from CC2541 to CC2340 device and has questions below,
The firmware is a UART <-> BLE bridge. There should also be the possibility of a signed…
