Answered

• CC2544: CC2544

  

  Gary Lin

  Resolved

  Part Number: CC2544 Hi Team, Customer is asking the question on the voltage protection on the cc2544 USB pin, in our data sheet it states only -0.3 to 5.5v on Vbus, customer thinking that normally we have diode protection on that pins, so like to know…

  • Resolved

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum
Answered

• CC2544: Sample code about Radio Test mode for CC2544

  

  Gandy

  Resolved

  Part Number: CC2544 Hi, Is there any sample code about radio test mode for CC2544?thanks

  • Resolved

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum
Answered

• RE: CC2544: Sample code about AES for CC2544

  

  Gandy

  Resolved

  It's work OK, thanks

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum

• CC2544: Sample code about USB Bootloader (Firmware update) for CC2544

  

  Gandy

  TI Thinks Resolved

  Part Number: CC2544 Hi Is there any sample code about USB Bootloader for CC2544?Thanks

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum

• CC2544: Why The Co-channel rejection wanted signal at -67dBm?

  

  Panchen Hsu

  TI Thinks Resolved

  Part Number: CC2544 Hello, In the datasheet CC2544 System-on-Chip for 2.4-GHz USB Applications datasheet (Rev. D) page 4, RF RECEIVE SECTION. Co-Channel refection Wanted signal at -67 dBm Does value -67dBm are specified by the certification? Can I change…

  • over 4 years ago
  • Other wireless
  • Other wireless technologies forum
Answered

• CC2544: NP0 capacitance is must ?

  

  Bruce li

  Resolved

  Part Number: CC2544 Dear TI Expert, My customer is evalating CC2544, they checked below CC2544 reference design and found many NP0 capacitance on different location. Are thest capacitance must NP0 or can be replaced by other category with same accuracy,…

  • Resolved

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum
Answered

• CC2544: Can not write flash in 0x7c00(32 page)

  

  Gandy

  Resolved

  Part Number: CC2544 Other Parts Discussed in Thread: CC2541 Hi , I have met on issue : when I try to write flash Page31 and page 32like below code 1 run at IAR debug mode , All run OK; 2 program by ""Flash programmer", the data in flash page 32 is OK…

  • Resolved

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum
Answered

• CC2544: How to update bin file to CC2544x using CCdebuger

  

  jack chen2

  Resolved

  Part Number: CC2544 Other Parts Discussed in Thread: CC2541 , CC2540 , Hi All, I want to update bin file to CC254x using CCdebuger. After check with flash programmer and flash programmer console, it seems not support bin file to update all of the flash. …

  • Resolved

  • over 5 years ago
  • Other wireless
  • Other wireless technologies forum

• CC2544: Frequency hop?

  

  BillyO

  Part Number: CC2544 Hi team, We had a customer request if the CC2544 is considered spread spectrum? Does it hop frequency if interfered with (reluctant hop) or is it like a WiFi that does not change frequency? Thanks for any details you can provide…

  • over 6 years ago
  • Other wireless
  • Other wireless technologies forum

• CC2544: CLK issue after power on.

  

  Kevin Segovia

  Part Number: CC2544 Hello, I am currently developing a USB Dongle + Remote control using the CC2544. When flashing using the CC Debugger, the code runs as expected, also after a reset. But when I power the board without the CC debugger (through the USB…

  • over 6 years ago
  • Other wireless
  • Other wireless technologies forum

Didn't find what you are looking for? Post a new question.