Hi Travis, thanks for you support.
could you share the BT certification test reports for QDIDs 69886, 85355 and 145296 via this or other channel ?
Under http://www.ti.com/tool/CC256X-CERTIFICATION
Hi Cherry,
The document was not included in your post, can you attach it in this thread?
Perhaps this CC256X-CERTIFICATION page will help the customer.
Best, Jacob
HI Ferdinand,
Actually we are already certified for Japan for the CC2564MODN. Note that is it only for the one antenna that is on our EM board. Please visit https://www.ti.com/tool/CC256X-CERTIFICATION. They use the Resources link to request the certificate…
Hi Koichiro,
I discussed with the concerned people about the internal details of the IC and they advised me to send you the following link. You need to send the request from this link and they will provide you the info.
Thanks,
PM
Hi There,
We only support the XTALS that are listed in the datasheet. These are 26MHZ and 38.4MHz. If you require the datasheet. Please use the following link to request this information: http://www.ti.com/tool/CC256X-CERTIFICATION When you go to…
Alain
Pls consult :
www.ti.com/.../CC256X-CERTIFICATION
processors.wiki.ti.com/.../CC256x_Regulatory_Compliance
Pls let us know in case you have any further questions.
Thanks
Saurabh
I have received some help locating the new page for the various test reports:
www.ti.com/.../SIMPLELINK-CC3XXX-CERTIFICATION
www.ti.com/.../wl18xx-CERTIFICATION
www.ti.com/.../cc256x-CERTIFICATION
Thanks,
Stuart
Hi,
I hope all is well. HCI command for testing can be found here: https://processors.wiki.ti.com/index.php/CC256x_VS_HCI_Commands . Note that this uses the HCI Tester SW that can be found here:
Note that for receiver blocking please reference…
Hi Fredj,
For conducted tests you want to use the U.FL connector with no matching. If you remove the antenna and place a coax cable where the antenna is, this will not be correct as the inductor is sued to match to 50 ohms as seen by the antenna.…
