Calling "SysCtrlSystemReset();" should be enough to induce a reset of the device.
A V said: However, were I to need an actual recovery from a hard fault / undesirable state, can I achieve this while allowing the CPU to sleep as expected for the…
Hi Karthick,
You should refer to the Debugging RF Output Debugging section of the Z-Stack User's Guide, but instead of using it for debug purposes you will connect these CC2652RB pins to CC2592 similar to how it is described in TIDC-CC2650-CC2592…
Part Number: LP-CC2652RB Tool/software:
I want check how it works in advertising mode using "Btool". I am trying to configure TI board with Btool in this It could be able to scan the devices,
and it is displaying the number of scanned device…
Ryan Brown1 said: It would not make sense for both zclFindAttrRec to return true and attrFound to be false.
I found that weird as well and have spent quite some time looking at this. I've also noticed that, inside zcFindAttrRec I got five consecutive hits…
Part Number: CC2652RB Other Parts Discussed in Thread: CC2652P7 Tool/software: Hi, I would like you to ask difference about CC2652RB and CC2652P74. According to datasheet, it seems that CC2652RB have internal 48MHz oscillator. So, if user change from CC2652P74…
A V said: When one of my own sensors has been disconnected(but still powered) for more than a week, I have to redo the whole pairing process to get it to work.
The Zigbee Coordinator has a End Device Timeout procedure (END_DEV_TIMEOUT_VALUE/NWK_END_DEVICE_LEAVE_TIMEOUT…
Part Number: LP-CC2652RB Tool/software: Hi
I'm trying to update firmware of XDS110 as below. But there will be disconnected between board and PC after switching device into DFU mode.
LED light is off after "xdadfu -m" command.
Did I miss…
Hello. I cannot provide sniffing logs as per the issues mentioned in
A V said: Regarding my issue with Packet Sniffer 2: the program does not detect any boards, though I see them in device manager.
This is an example of setting Reporting Config and getting…
Part Number: LP-CC2652RB Tool/software: Hi, I am trying to transmit BLE data at particular channel by instructing the controller directly. I see that technical manual mentions that there is generic command to receive operation ` CMD_BLE_GENERIC_RX or…
