Part Number: CC3135MOD Other Parts Discussed in Thread: CC3135 , UNIFLASH I am bringing up a new custom control board that uses STM's STM32H50XBH6 as an embedded MCU and integrates the TI CC3135MOD module for Wifi connectivity. An earlier version of the…
Part Number: CC3135MOD Reference to Table 9-2 of CC3135MOD datasheet, we have FCC, IC/ISED, ETSI/CE, MIC certificates.
When customer is making the final certification procedures at these countries/standards, whare are the test items that they can skip…
Part Number: CC3135MOD Hi
in CC3135MOD data sheet, it says that either nRESET (Pin 35) or nHIB (pin 4) can be used for Device Restart and Reset.
So, we have to choose which one (either nRESET or nHIB) we are going to use for Device Restart and Reset…
Part Number: CC3135MOD Other Parts Discussed in Thread: CC3135 Dear Expert,
I would like to know the following wrt CC3135MOD:
1. What is the t hroughput of module CC3135MOD ( rx/tx)
2. I saw in eval kit module supports U.FL antennas, and M830520 ceramic…
Part Number: CC3135MOD Other Parts Discussed in Thread: CC3220S , CC3220SF , , CC3135 , CC3235SF Dear Expert,
According to SWEU534D https://www.ti.com/lit/ug/swru534d/swru534d.pdf
It only mentioned this is supported in CC3200R, CC3220S, CC3220SF.
Can i know…
Part Number: CC3135MOD Other Parts Discussed in Thread: CC3135 , CC3235SF Dear Team,
We now need to put the CC3135MOD in the emitting state of maximum power consumption for thermal testing,
how to configure the maximum power consumption as shown below…
Part Number: CC3135MOD Hi
I am now looking at SWPA231 CC313x Wi-Fi Embedded Programming app note which is using UART interface to program CC3135MOD Flash from third party MCU.
and I am using SPI interface between CC3135MOD and STM MCU, and trying to…
Hi Shlomi,
with the change to the static memory mgmt, we finally completed sl_Start.
and then when execute sl_DeviceGet, we got Get Verison Fail -2005 as below.
So, please advise me what else we need to check for moving forward?
Here is the log from…
Part Number: CC3135MOD Other Parts Discussed in Thread: UNIFLASH I use "uniflash 7.2.0" to configure the 5GHz channel TX power because our product transmits with too much power, so we achieve a fail in certification process. We want to use the…