Part Number: CC8531 Our customer plans to use this solution to design a wireless microphone and need apply for certification of FCC ID, RED, SRRC, TELEC ID So below testing mode is needed: Hopping (low/middle/high channel), TX, all Data rate Non Hopping…
Part Number: CC8531 In "CC85XX_DK" EVM Board (CC85XXDK-HEADSET_UG.pdf) Press and hold the "CSN" port for power on/off to turn the power on/off. Can I change "CSN" port to Lock(High)= ON , unlock(Low)= Off?
Part Number: CC8531 Hi, TI support team
This is an inquiry about the inductor applied to the reference circuit below.
Does the value of 6N8 applied to L2, L5~8, and L10~15 have to be applied?
Why was the inductor applied to that part?
If it…
Part Number: CC8531 hello:
Our company has a number of wireless products that use cc8531. We hope to pair the host and slave through buttons.
I have some questions.
Do we still need to write the device ID in this way?
After the device is powered…
Part Number: CC8531 Other Parts Discussed in Thread: TLV320AIC3204 , TLV320AIC34
Hi Team,
1. I use CC85XXDK-Headset on 1 master and 4 slaves. The 4 slaves perform audio input and send data to the host through wireless wave, and the host performs…
Part Number: CC8531 Hi TI experts,
Customers want to change the name of the headset they connect to their PC. They developed the headset by applying the CC8531.
When connected to a PC, the device name is recognized as CC85X1.
Mic - CC85X1 USB Headset…
Part Number: CC8531 I have been unable to find a crystal that matches the specifications called for by the data sheet, and the part listed in the demo design is obsolete.
Custom / non stock / long lead time parts are not an option.
The required spec…
Part Number: CC8531 Other Parts Discussed in Thread: CC2590 I am designing a microphone using CC8531 & CC2590. Since I am aiming for a small form factor, I have decided to use a chip antenna instead of the PCB antenna on the evaluation board designs.…
Part Number: CC8531 Hello.
My product is undergoing a certification test.
The tester is asking for a hopping test mode, but I don't know what to do.
Because the
The tester is asking for a hopping test mode, but I don't know what to do. I modified…
Hi Sean,
1) yes, you would use the EHIF commands to interface with the CC8531 in host-controlled mode. These commands only allows you to read the IO state, not control it (only in the test image you could do this).
2) Not sure what you are asking…
