Part Number: CD4052B Tool/software: Hi,
I am working in a project with S32G3RDB3 board on BSP 43 version. We are using the CD4052B analog multiplexer in a Linux-based embedded system and would like to know if TI provides any Linux-compatible driver…
Part Number: CD4052B Other Parts Discussed in Thread: LMH6612 , TMUX1109 , TMUX1209 Hi TI Expert,
I currently have a circuit configured as: Hall Current Sensor → LMH6612 → ADC → FPGA.
I need to expand this design to support multiple current sensor…
Part Number: CD4052B Other Parts Discussed in Thread: SN74LV4052A , CD74HC4052
Hello,
My current design use CD4052B with 3.3V VDD and I suffering from huge resistance above 10Khz switching frequency on A and B pins,
I saw many suggestions from…
Part Number: CD4052B Tool/software: Hi, TI expert
The customer has been applying CD4052BPWR to Manual Defibrillator/Monitor products for years without any problems.
However, in recent product production, a defect occurred where the impedance measurement…
Part Number: CD4052B Other Parts Discussed in Thread: TMUX7309F , TMUX7349F Tool/software: We are using CD4052B in an automotive LIN circuit. While most of the time it works fine, we found that some were damaged. The voltage should not exceed 15V under…
Part Number: CD4052B Other Parts Discussed in Thread: TXS02612 , TS3A27518E Tool/software: Customer is looking for similar function with below device. Pls help on this. Very thanks.
https://www.mouser.com/datasheet/2/308/1/FSSD06_D-2314271.pdf
Regards…
Part Number: CD4052B Tool/software: The on resistance of CD4052BM96 is much lower than the specification sheet. Here is a comparison between our actual measurement value and the specification sheet. What may be the possible reasons for this phenomenon…
Part Number: CD4052B Tool/software:
The picture shows 2 different X ray from different COC.
The left one with DC2022 was made in China, while the right one with DC2024 was made in Malaysia.
it shows the X ray is different. is that normal? and do…
Part Number: CD4052B May I know the impact of X COM and Y COM is both shorted. It was 5V square wave out puts both mistakenly shorted, I am getting garbage value of outputs now. May I know the impact if Outputs shorted.
