Part Number: CDCE925 Hi team,
My customer is considering using multiple CDCE925s on a board, and has question on its slave address setting.
On the datasheet, Table 5 shows slave receiver address. It states that A1 and A0 are programmable, and user can…
Part Number: CDCE925 In the datasheet, and CLock PRO software, it mentioned that out clock has zero ppm error, what does it mean? does it mean the output clock has zero phase shift with input clock signal? thanks
Part Number: CDCE925 I am currently using CDCE(L)925 for generating a system clock. The input is 96MHz with a target output of 192MHz on Y1. As of right now I can get the output to match the input clock or have Pdiv1 divide it. However, I am not able to…
Part Number: CDCE925 Other Parts Discussed in Thread: LMK00304 , LMK1D1204 , CDCDB400 , CDCE706 , CDCE6214 , CDCE18005 Hi Team,
For the CDCE925PWR chip, is it possible to have Y2 be an inverted Y1 signal, (likewise can Y5 be the inverted Y4 output).
If it…
Part Number: CDCEL9XXPROGEVM Other Parts Discussed in Thread: CDCE925 , CLOCKPRO , , CDCEL925 Hello,
I am trying to use the CDCE925 programmable clock generator IC on a board design. Ultimately we would like to be able to program the chip on-board via I2C…
Part Number: CDCE925 Other Parts Discussed in Thread: CDCE937 Hello,
The cdce925 datasheet mentions two "variant" of this device: CDCEx925: 2-PLL, 5 Outputs CDCEx925: 3-PLL, 7 Outputs Later in the datasheet in the table 5 "Slave Receiver Address…
Part Number: CDCE925 Hello
I am using I2C communication to program this board, and it has been working perfectly, and It suddenly stopped programming all of the sudden. When I ran the debug session in STM cube IDE session, it just wouldn't even go through…
Part Number: CDCE925 Other Parts Discussed in Thread: CLOCKPRO Hello.
I am able to read and write from the register, and I am not able to get this register to provide the desired PLL output.
I am using 16Mhz Crystal, and this is code I used to get the…
Part Number: CDCE925 Other Parts Discussed in Thread: CLOCKPRO Dears:
KMM customers need support for the following problems when debugging CDCE925. Could you provide them? Thank you!
Question:
When the customer uses the ClockPro GUI to configure VCXO…
Part Number: CDCE925
Measure the output Y1 and Y4 of this IC, there are obvious differences after comparison normal and abnormal.
It can return to normal after we replaced other IC. If we using in other good boards, abnormalities will still occur
so…
