Part Number: CDCEL949 Other Parts Discussed in Thread: CDCEL913 Hello,
When I click the CDCEL949 IC datasheet, I see CDCEL913 IC name attached as below, could you please check ?
Part Number: CDCEL949 Other Parts Discussed in Thread: CLOCKPRO , CDCEL9XXPROGEVM Team,
my customer is looking for solutions to program CDCEL949 (directly on their custom design board with the devices soldered to it). According to ClockPro, they need…
Part Number: CDCEL949 If 2 dividers are programmed to be the same value, particularly the 10-bit divider, and the 7-bit divider, Are there any guarantees that two dividers would reset and start up on the same clock, so that out the outputs would be phase…
Other Parts Discussed in Thread: CDCEL949 The spectrum I get from the device isn’t very clean , which is causing problems with the DDS it’s driving (see the image below).
The evaluation board was powered by a clean linear power supply, and the setup…
Part Number: CDCM6208 Other Parts Discussed in Thread: CDCEL949 , LMK1C1108 Tool/software: Hi,
Please recommend a TI clock driver with the following requirements:
(1) Input channel number: 1, output channel number: 8;
(2) Operating frequency: 72MHz;…
Part Number: CDCEL937 Other Parts Discussed in Thread: CDCEL949 Hi support team.
There doesn't seem to be an EVM for DCEL937, is there any recommendation in the environment to evaluate?
Could you please provide the info about it?
Best regards, …
Hello Darren,
The fractional noise in CDCI6214 is expected to be higher. For your application, I'd recommend using
http://www.ti.com/lit/ds/symlink/cdcel949.pdf
Best regards,
dinesh.
