Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: CDCLVD1216 Dear Sir,
We need to distribute 2 signals (2-5KHz and reset(DC) ) into 90 signals each.We identified part CDCLVD1216 to use in two levels.Please confirm whether the part is suitable for this application.Also suggest if any other…
Part Number: CDCLVD1216 I am using this IC to distribute signal (2-5KHz) tousing this IC and drive to 2 m length.Whether this IC is sufficient for drive or i need to use LVDS driver additionally.
Part Number: CDCLVD1216 Other Parts Discussed in Thread: CDCLVD1208 , Hi Ti experts,
We have some doubts about power supply for clock buffer cdclvd1216 and cdclvd1208.
As we search from the datasheet, there are no special requirements for power supply, such…
Other Parts Discussed in Thread: CDCLVD1216 , CDCLVD1212 , CDCLVD1208 Can you clarify something in the data sheets for CDCLVD1208, CDCLVD1212, CDCLVD1216 for me?
The data sheet specs for part to part skew, propagation delay typ and max do not seem to be…
Other Parts Discussed in Thread: CDCLVD1216 Please let me know about CDCLVD1216.
Datasheet 12-page figure-7 is attached.
Is VPP(1.6V) a single-ended value?
Or a differential value?
Best regards,
Satoshi
Other Parts Discussed in Thread: CDCLVD1216 Hi,
Would you please advise where 100ohm termination should be placed for CDCLVD1216 LVDS output ?
As the datasheet Figure14 says, should the termination be placed between ac-coupled capacitance and LVDS device…
Customer are examining whether IN_SEL can be used as "CLK_EN".
・IN_SEL="1"
⇒High level with 1komega pull-up
⇒INP1/INN1 Input
・IN_SEL="0"
⇒Floating
⇒None
Is such usage possible?
Best regards,
…
Other Parts Discussed in Thread: CDCLVD1216 Dear Sir/Madam,
Page 5 of CDCLVD1216 states that VIN, DIFF "differential input voltage peak-to-peak" is 0.3V (min).
Q. Is VIN, DIFF the same as VID?
The reason why I ask is that most LVDS drivers including…
The following patterns are examining the client.
The following pattern is expanded the question part.
(0.01μF & 3Ω)×2 are connected near VCC.
Is the above-mentioned pattern right?
If pattern is right, what role is this connected? …
Other Parts Discussed in Thread: CDCLVD1216 Hell, one Question.
I have a question about the IBIS-Model of CDCLVD1216. I IBIS simulation using the Line Simv8.2.1 of Mentor . Simulation at the start , an error message is displayed . Why is this IBIS model . Please…
