Hi Vicente,
Thank you for your response.
The customer's input is 24.576MHZ and the output is 24.576MHZ. How do we configure the PLL parameters using ClockPro?
Best Regards,
Amy
Hi Vicente,
I appreciate your prompt answer.
1. Please find the attached screenshot of the .init files that we used for programming.
2. We aren't using ClockPro GUI since CDCE62005 isn't supported by it (as stated on ti's website at https://www…
Hi Amy,
My register map does not match the customers.
Our EVM schematic also does not match the customers. I would need some time to see if their schematic is the cause of the issue. CDCEL913 ClockPro 1.196Mhz output CSV File.ISF.CSV CDCEL913 ClockPro 1…
Hi,
My customer asked us following question about "Reset PPM refernce".
* When user pressed this button, could you tell us which registers are set ?
I think that variable of this GUI program is just cleared by pressing "Reset PPM reference…
I am currently having a similar problem but it is slightly different.
I install ClockPro software but I always get TUSB3410 Device in the Device Manager and it has the ! on the device.
When I look at the properties this is what it says
Windows cannot…
Hello,
Since you are able to read and write the problem likely lies in the register settings:
Young Shin said: Variables I used were fout = 32Mhz, Fvco = 64MHz, P=2 n'' = 4*2^2 = 16 Q=16, R =0
fvco range is 80 MHz to 230 MHz.
Please increase that…
Other Parts Discussed in Thread: CLOCKPRO , TUSB3410 I am trying to install TI ClockPro (SCAC119d). It stops when trying to install the driver for the TUSB3410 with the message, "unable to Launch usbinst. "
Please help,
The PC is XP, SP3
I looked…
Other Parts Discussed in Thread: CLOCKPRO , CDCE925 What support documentation can you provide to enable the creation of an embedded "home grown" version of an application that works like ClockPro to enable a system to reconfigure the CDCE925 on the fly…
Part Number: CDCEL9XXPROGEVM Other Parts Discussed in Thread: CDCE925 , CLOCKPRO Cannot get the clock pro software to connect to the EVM board. I'm running Win10 and I can see the device in the device manager on port 10. By disabling driver signing…
Other Parts Discussed in Thread: CDCE706 , CLOCKPRO , TPA2006D1 Hi
In the state equipped with CDCE706 to the board that I have designed, you want to write in the EEPROM of CDCE706 using ClockPro.
exp) PC(ClockPro)USB --> CDCE706(on board writing)
When…