Part Number: CSD15571Q2 Regarding the transistor (CSD15571Q2), what about RDS (OFF), how high is it? Since we are using this device as switch we not only want that RDS ON be very low, but also RDS OFF to be very high, please provide the information you…
Part Number: CSD15571Q2 Hi Team,
Would you please provide the ESD rating on HBM for CSD15571Q2? I can't find the data inside the datasheet. Thanks.
Best regards,
Andy Chu
Part Number: TPS552882 Other Parts Discussed in Thread: CSD15571Q2 , CSD16301Q2 Hi,
We're building an LED matrix display, and are using two independant TPS552882 power supplies. The design criteria for these two supplies is as follows:
White LED supply…
Part Number: CSD15380F3 Other Parts Discussed in Thread: CSD15571Q2 I see that this part is not recommended to be used with copper greater than 1oz. Is there a similar fet (with very low leakage) which can handle 2oz?
Other Parts Discussed in Thread: LMG1020 , CSD17571Q2 , CSD15571Q2 , CSD16301Q2 Dear sir ,
i want to create a signal from Arduino Due at 5MHZ (a square wave ) 50% duty cycle to be connected to fast gate controlled mosfet(NPN) to switch a load 12 volt 1 …
Hi Zhang,
In the TIDA-00663 we are also showing the discrete solution using the SPL PL90_3. This is at pag 3 of the TIDA-00663 schematic: http://www.ti.com/lit/df/tidrpa0/tidrpa0.pdf?ts=1591082481004 .
In this case we have selected the CSD15571Q2, but I think…
Hello Jimmy;
Thanks for your reply it is very detailed and useful for us.
1-Regarding the Hysteresis, since the tolerance of the input voltage is a little bit lower than 12V we would prefer using a value near 11.7V.
Because if I understand correctly,…
Other Parts Discussed in Thread: CSD15571Q2 Hi,
I followed the sluu463 EVM schematic for the battery charging IC, I changed the some of the components in the schematic as I don't have that components right now, the changed components are as follow…
Other Parts Discussed in Thread: CSD15571Q2 , BQ24170 Hi,
I followed the sluu463 EVM schematic for the battery charging IC, I changed the some of the components in the schematic as I don't have that components right now, the changed components are as…
