Part Number: CSD17570Q5B Other Parts Discussed in Thread: CSD17573Q5B Hello
What are the specific reasons/parameters why TI publishes " not intended for switching applications" for the low Rds N-FET 'CSD17570Q5B'?
Regards
Tom
Part Number: CSD16570Q5B Other Parts Discussed in Thread: CSD17570Q5B , CSD16556Q5B , CSD17573Q5B Hi team,
My customer need to find Pin to Pin device of both CSD16570Q5B and CSD17570Q5B, In fact, I have find some devices searched for similar products…
Part Number: CSD17570Q5B Hi Expert,
The application is from the redundant power supply.
The continue current will go through the body diode for a certain period.
Conditions:
Vo=12V
Io (into body diode) =31A
Duration=1.87mS
Pls advice…
Part Number: TPS1211-Q1 Other Parts Discussed in Thread: CSD17570Q5B Dear
I am seeking assistance with slow rate optimization.
My design uses four MOSFETs CSD17570Q5B connected in parallel, each connected to a TPS12110 driver via a 2.7 ohm gate resistor…
Part Number: TPS2490 Other Parts Discussed in Thread: CSD17570Q5B Tool/software: We use TPS2490 to power on a 10mF load. I have used the design calculator, but I get that the minimum slewrate is higher than the max slewrate. Does this mean I can not used…
Hi Sarah,
Although customer have conducted his own evaluation,
I would appreciate it if you could kindly review whether the RC network at the gate still requires further optimization,
taking into consideration factors such as MOS SOA and inrush…
Part Number: BQ4050 Other Parts Discussed in Thread: CSD17570Q5B , BQ24600 Hi,
Configuration is as follows:
1. Using 4S1P lipo cells 8000mah
2. Load used while discharging of 7A
3. CSD17570Q5B (30V, 100A) as CHG and DSG FET
After charging the…
Part Number: LM25069 Other Parts Discussed in Thread: TPS25982 , CSD17570Q5B , CSD16415Q5 Hi team
Could you help check if LM25069 + CSD17570 is suitable for 16.5A Iout application?
Vin=12V&5V
Iout=16.5A
The customer prefers to hot-swap device…
