Part Number: CSD23280F3 I want ask to you the following information regarding the solder process:
Suggested thickness for the stencil in the datasheet
Suggested type of stencil: cut technology and type of material (fine grain, super fine grain)
…
Part Number: CSD23280F3 Other Parts Discussed in Thread: TINA-TI As shown in my snap shot, we see the diode drop while it shouldn't. Can you confirm I'm not crazy, in case I'm not, can it be fix?
From CSD23280 datasheet:
Part Number: CSD23280F3 Other Parts Discussed in Thread: BQ25505 , , CSD23202W10 The TI bq25505 support group has recommended a PMOS FET to protect from polarity reversals on the bq25505 input that I am using in a new design. TI support (Ricardo) provided…
Part Number: CSD23280F3 Hello TI, about your CSD23280F3 datasheet ("SLPS601A, 2016 Revised August 2017") possibility of a datasheet typo?
On page 1, Absolute Maximum Power Dissipation is 500mW. Note 1 (page 1) also says 1-in-sq of copper is required…
Part Number: CSD25484F4 Other Parts Discussed in Thread: CSD23280F3 , Tool/software: Gate-to-Source Voltage value of CSD23280F3 described as -12v, Is it a typo error ? should it be +12V ,-12V?
Part Number: BQ25120F3A Other Parts Discussed in Thread: CSD23280F3 Tool/software: Hi TI Team,
I am Nithin, a HW Engineer working in Innominds Software Pvt Ltd. I am working on the Nymi Gen 4 project. We are in the process of Compliance testing, for…
Part Number: CSD15380F3 Other Parts Discussed in Thread: CSD23280F3 , Hello Team,
I'm compering the N and P channel MOS.
On the N channels since they are physically smaller (electron mobility is better than hole mobility) I'm not surprises that Qg…
Jeevan,
You were correct and the spice model on the web had the diode configured backwards. Please use the attached. We are working on updating the model online.
Again, thank you for highlighting this to us.
CSD23280F3.TSM
Hi Brett,
Does this same advice apply to the other FemptoFET devices, like the P-channel CSD23280F3 and CSD23381F4? I assume that if an application does not apply a reverse bias to the gate, there is no need to worry about series current limiting resistance…
