Part Number: CSD95379Q3M Hi,
we want to use this part to drive an inductor that is tied to VCC/2 on its other end. Current needs to flow in both directions. This part seems to be suitable for this when used in forced CCM. As there is no evaluation board…
Part Number: CSD95379Q3M Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hello. I have a few questions about CSD95379Q3M. 1. In datasheet: Do not start the driver in the very low power mode (SKIP# = Tri-state). What time…
Part Number: CSD95379Q3M Hello,
Below is customer waveform. negative voltage -2.7V is about 13ns. That voltage and timing looks not specified on datasheet just only -7V <10 ns specification. Has any damage concern for this waveform? Thank you.…
Part Number: CSD95379Q3M Hi,
We are planning to use CSD95379Q3M in hysteretic buck converter. Our application requires control FET to turn on with the first toggle on PWM pin only. Initially when we start the operation for first time, we suspect that the…
Part Number: CSD95379Q3M Other Parts Discussed in Thread: DRV595 Hey E2E NexFET.
Can I use NexFETs for a 6-8V output Buck from 12V?
Sorry if that's a dumb question. The data sheet shows Abs Max on Vin - Vsw & Vsw - Pgnd as being 20V so I don't see…
Part Number: CSD95379Q3M Other Parts Discussed in Thread: LP2985 , I'm having some issues with this part not switching on startup. I'm using two of these to form an H bridge for bipolar control of a TEC element.
My setup:
Vdd = 5V, Vin = 3V
Skip#…
Part Number: CSD95379Q3M Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hi,
I want to use the CSD95379Q3M in my design. Therefore I want to simulate it beforehand.
I'm struggling implementing it in LTspice. My error message…
Hello,
I checked all power stage parts and did not find any P2P with lower UVLO. I found CSD95379Q3M. Block diagram does not show UVLO on VIN but it is not P2P.
Regards
Hello,
Most smart Power Stages were designed for multiphase synchronous Buck application.
For 25A/30A Boost converter you can use CSD96370Q5M or CSD96371Q5M.
For 12/15A Boost converter you can use CSD95379Q3M or CSD95377Q4M.
Best regards,
Lucian
Part Number: TPS51623 Other Parts Discussed in Thread: CSD95379Q3M , Hi,
The schematic is using TPS51623 with CSD95379Q3M, could you help to check that the schematic(marked with red box) is good to go or not?
Thank you very much!
Q7 _ 25-POWER_ VCC_VCORE…