Part Number: DAC101S101-Q1 Hello,
This is Carmen, from TNES Purchasing Section. I hope this email finds you well.
I have been trying to ask for this PN IMDS Submission but it did not find it in the dropdown list.
How can I ask for this submission…
Part Number: DAC101S101 Hello:
DAC101S101CIMM datasheet shows operate temperature is 235℃。10 seconds. But our actual operation temperature is 245℃。 Could you help to check with your technical whether we can operator in 245℃？if no, what is the highest…
Part Number: DAC101S101 Hello,
in DAC101S101 in package SOT-23 (6) (DDC0006A) isn't clear the Pin-1 of the component, the real component seems different from that is shown on Component, see following Print Screens. In real component there is white…
Part Number: DAC101S101 Other Parts Discussed in Thread: DAC121S101 ,
Hi everyone,
I try made a little firmware on STM32 to control this DAC but I don't find the mistake, because I read the datasheet, I tried make this work but is impossible, and…
Part Number: DAC101S101 Other Parts Discussed in Thread: DAC8830 Hello Team,
The datasheet described the digital feedthough is 0.5nV-s. however my customer request waveform similar as following.
(This waveform from DAC8830 datasheet)
Is the…
Part Number: DAC101S101-Q1 Other Parts Discussed in Thread: DAC121S101-Q1 , Hello team,
I want to make sure that DAC101S101-Q1 is the same as DAC121S101-Q1, except for the resoultion (10bit, 12bit).
If not, would you please tell the differences…
Part Number: DAC101S101 The figure below is the normal/abnormal comparison we collected. Both pictures are setup to 0200, which corresponds to convert data to VOUT = 2.5V. But the DAC VOUT in the right picture will suddenly drop.
We find when we write…
Part Number: DAC101S101 Spec. recommends that Bypass caps need to use 10uF tantalum cap + 0.1uF. But tantalum caps are not allowed on EV products, so when doing data review, our design does not match the original manufacturer's recommendations. The current…
Part Number: DAC101S101-Q1 Hello,
On the datasheet there is no maximum for the VIH on the digital inputs.
On "7.4 Recommended Operating Conditions" the "Any input voltage" maximum is marked as (VA+0.1)
But remark 4 state "analog inputs" and not…
Part Number: DAC101S101 Hi,
Iam using DAC101S101 Digital to analog converter based on SPI.
So Iam connecting the microcontroller with the DAC using SPI using SCLK, SYNC and DIN.
How do I get notified in my microcontroller if some DAC communication…
