Part Number: DAC1220 Hi team,
Could you tell the output value of DAC durign three conditions below?
1. After powerup, before startup
2. during startup
3. during calibration
Regards,
Noriyuki Takahashi
Mark,
While the DAC1220 might have some chopper stabilization, the clocking for the stabilization would be much smaller than the many seconds that you are seeing. Typically, you'd want chopping in the 100s of kHz range for most applications.
Also…
Part Number: DAC1220 Other Parts Discussed in Thread: DAC11001A Hey team,
I have a customer looking to upgrade from the DAC1220E. I do see on the webpage that the DAC11001A is the recommended upgrade, and would be happy to suggest that, but my customer…
Part Number: DAC1220 Other Parts Discussed in Thread: DAC11001B , Hi Dear,
The customer is producing a flowmeter product and requires a positive and negative 10V voltage signal at the output end, with a transmission distance of 15 meters.
1- Is there a…
Part Number: DAC1220 Other Parts Discussed in Thread: DAC8560 , DAC11001A Hi Team,
Hope everything goes well. One customer were facing a problem while using our DAC1220.
Q: when system power up, it will takes 100ms for MCU(F2803x) to wake up. Before F28035…
Part Number: DAC1220 This is my first time using a DAC1220. I am using it to drive the OCXO (set the frequency) in a GPSDO. I believe I have gone through the initialization process, but somehow it's not working properly. It appears that it is staying…
Part Number: DAC1220 Other Parts Discussed in Thread: OPA2171 ,
Hi TI Technical Support Team,
I have designed a board that includes TI 20bit DAC DAC1220 and my aim is to sweep the voltage of the load connected to my board. I am mapping 0-5V output of…
Part Number: DAC1220 Other Parts Discussed in Thread: OPA350 , OPA2171 , OPA2197 Hi TI Technical Support Team,
I am planning to use DAC1220 20 bit DAC for my application. My question is regarding the choosing Vref IC for DAC1220. The DAC1220 EVM reference…
Part Number: DAC1220 Hi team,
My customer is using DAC1220 for analog output, and they have tested 5 samples, all of them output 2.56V at power up, which is not desired. I've recommend to write register CALPIN to disconnect output during calibration,…
Part Number: DAC1220 Hello!
The datasheet is a little ambiguous about exactly what's going on at the Xin and Xout pins. It is stated that a 2.5 MHz crystal is recommended for best performance. If nothing is connected, does it have it's own internal…
