Part Number: DAC3484 Other Parts Discussed in Thread: LMK1C1108 Tool/software: Hi Team,
My board clock requirement block diagram is attached below.
The clock from the clock synthesizer need to feed as input clock to all ADC, DAC and FPGA in the board…
Part Number: DAC3484 Tool/software: Hi team，
The reset signal of DAC3484 is not connected to GPIO in the customer design, so there is no way to control it, and it can only be enabled by the internal pull-down of the chip. Is this reset toggle necessary…
Part Number: DAC3484 Tool/software: Hi, Sir,
Can I use DAC3484 as simple DAC converter? we follow power up sequence(from datasheet), after RESETB toggle, we start configure register,
I disabled QMC,NCO,Interpolation filter and PLL, But when I check…
Part Number: DAC3484 Tool/software: Hello everyone.
While working on a system (Avnet Microzed card connected to a PCB with several modules, including two ti DAC3484), I got additional phase noise in my datapath.
While working with data of zeros and…
Part Number: DAC3484 Other Parts Discussed in Thread: CDCE62005 , , DAC3482 Tool/software: Hello
I am configuring a system consisting a FPGA board (Avnet Microzed 7020), connected to a custom board consisting 2 DAC3484 and a CDCE62005.
My initial…
Part Number: DAC3484 Other Parts Discussed in Thread: CDCE62005 , Tool/software: Hello,
I am experiencing some difficulties in the usage of the DAC3484 on my PCB. the system that I am using is a FPGA card cunnected to a PCB with two DAC3484 and a CDCE62005…
Part Number: DAC3484 In our application we are using the DAC3484 component whose function is to generate a 334.7MHz frequency carrier with single sideband modulation with a frequency of 4KHz. The input clock to the DAC (DACCLK) has a frequency of 1229…
Part Number: DAC3484 Other Parts Discussed in Thread: CDCE62005 , Tool/software: Hello,
I am new to the DAC world and trying to start my first design.
my system is built from an Avnet Microzed 7020 FPGA board, connected to a PCB with 2 DAC3484 and…
Part Number: DAC3484 Other Parts Discussed in Thread: LMK04826 , Tool/software: Dears,
My customer is using DAC3484 in a RF station project, and find the measured IMD3 may be <60dbc at some frequency range, the performance is not qualified as the…
