Hi Deva,
When using the AFE7906 the SYNCB-OUT signal is not required and can be left unconnected or used as a general GPIO pin.
The JTAG can only be used to perform boundary scan. When not being used JTAG Test Reset must be pulled low.
Please…
Mark,
Using the DAC38RF82EVM with the TSW14J56EVM is the fastest solution available today. You would be able to do 2 channels at 9Gs/s with 16 bit input data but would require the DAC to use a minimum of 8x interpolation with complex data. If using…
Jim
I have got my hands on both boards, the Virtex-6 ML605 and ADS54j40EVM, as well another board : DAC38RF82EVM, and it seems ML605 support the JESD204B IP core
My apologies for late answer
regards,
Abdallah
User,
The GUI can be found under the software section under the DAC38RF82EVM product folder on the TI website. The GUI can also be found under the DAC38RF82 product folder as well. This is version v2p0.
The mode you mentioned above can only be used…
Hi, It seems there is a problem when saving the configuration using the TSW40RF80EVM GUI so what I have done is set up an DAC38RF82EVM in our lab using and then combined the saved configuration from the DAC38RF82EVM with the LMX2582 configuration from…
Other Parts Discussed in Thread: DAC38RF82EVM I'm using the HMC6350EK1 evaluation kit from Analog devices to transmit data at 60GHz. We are looking to build a demonstrator outputting high data rates using a digital modulation scheme over the 60GHz link…
Hi Kang,
Thanks for your prompt reply. For me, the "missing piece" of the equation for automating the initiialization/ startup of the DAC38RF82EVM is the "FTDI Pattern File" you identify in your "DAC348xEVM_Labview_SPI_Software.PPTX" document. For the…
Hello,
Information about the EVM pins can be found by viewing the schematics in the EVM design files. The design files can be found at the links below.
http://www.ti.com/tool/DAC38RF82EVM
http://www.ti.com/tool/ADS54J40EVM
Thanks.
Yusuf
DAC38RF82_PLL_122p88M_ref_841.pptx DAC38RF82_PLL_122p88M_ref_841.cfg Scott,
Please see the GUI settings used in the attached presentation and the attached configuration file. These were used on the TI DAC38RF82EVM with your settings the best I could…
F,
Go the DAC38RF82EVM product folder on the TI website. You can down load the GUI from here. The EVM and GUI covers all of the parts in this family.
Regards,
Jim
