Part Number: DAC38RF90 Other Parts Discussed in Thread: DAC38RF80 Hi Team,
Customer has below question need your help.
1. Use the DAC PLL clock as the serdes PLL reference signal (both DAC cores are enabled and configured in the same way): a. The…
Part Number: DAC38RF90 Other Parts Discussed in Thread: LMK04828 Hi Team,
Could you please comment on the minimum value of VI(DPP)? Thanks!
Regards， Hailiang
Part Number: DAC38RF90 Other Parts Discussed in Thread: DAC38RF80 , TSW14J57EVM Hi,
I would like to test the DAC38RF90. It seems that only the DAC38RF80 has an Evaluation board and the datasheet for the EVM states that a TSW14J56EVM is needed. But…
Part Number: DAC38RF82EVM Other Parts Discussed in Thread: LMX2594 , DAC38RF80 Dear forum members,
we do have the problem of high phase noise / jitter when using the DAC38RF8x internal PLL.
We would like to get information where root cause of the…
Kailyn,
You will have to configure the device first then start the initialization sequence before SYNC will go low. See section 9.1 of attached data sheet.
Regards,
Jim
DAC38RF8x Data Sheet.pdf
Hi Xlaodie, please see my comments below.
XIaodie Hu said: Combined with TSW14J57EVM, I only use the "on-board VCXO clock mode" of DAC38RF82EVM. What is the frequency range of sinusoidal signals generated by DAC38RF82EVM?
The frequency range which…
Hi Jonathan,
This is an error in the GUI. It should be possible to select 16x interpolation for the mode you are trying to use.
Can you replace the following file with the one attached: modes_n_clock_programming.tx t
The file can be found in C…
