Part Number: DAC5688EVM Other Parts Discussed in Thread: DAC5688 Tool/software: Hi expert,
could you help to recommend a paring pattern generator board for DAC5688?
Br
Chi
Part Number: DAC5688EVM-SW Other Parts Discussed in Thread: DAC5688EVM Hello, Does DAC5688EVM software/GUI work under Windows10 environment? Best regards, K.Hirano
Part Number: DAC5688EVM Other Parts Discussed in Thread: DAC5688 , CDCM7005 I have installed the S/W from both the CD and the web and the DAC5688 driver shows up as "Other devices" DAC5688 driver unknown. I am using this attached to a TSW1400EVM board…
Other Parts Discussed in Thread: DAC5688 , DAC5688EVM Hello,
I would like to ask you how to set/configure GUI of DAC5688 and "High Speed Data Converter Pro" to output mixing 63.86MHz signal from 102.5MHz(NCO)+38.64MHz(DAC input).
The hardware conditions…
Dear Kang-san
Thank you for the detailed reply.
Moreover, please let me know one more point.
LED6&LED7 of TSW1400EVM does not light up certainly. If there is the method of light "on certainly", please let me know.
A situation is written to below…
Part Number: TRF3703-33EVM Other Parts Discussed in Thread: DAC5688 , DAC5688EVM We have been working with the TRF3703-33 part and are wondering if there is a development board that has the below with an FPGA for the data_in interface?
I did see a DAC5672EVM…
Here is the post that I am mentioning.
If you confirme me that I can use the Dac5688evm to output a DC signal without any modification then I'll purchase one sample.
Otherwise what type of evaluation board do you advise me to use? Same characteristics…
Hi Gal,
The CLKO_CLK1 output is at IOVDD which is 3.3V logic for the DAC5688. The need for a buffer will depend on your system design and loading current on the pin. Please be aware the CLKOUT delay relative to input CLK2 rising edge will increase with…
Other Parts Discussed in Thread: DAC5688EVM Hi~
If see DAC5688EVM, mentioned TSW3100 as Digital Test Pattern Generator.
But We have TSW1400.
Can we use TSW1400+DAC5688EVM?
Hi Dan,
Yes, I do have a DAC3283EVM Rev D. When I run the GUI as an Admin, I get a warning on device communication failure, which is interestingly recognized by Windows as DAC5688, and therefore is not recognized by the GUI for DAC3283EVM. To my surprise…
