Part Number: DAC60501
DAC60508M and DAC60501M
We have now build the first circuit around the DAC60508M
During power up of the IC we are surprised to see the Output (OUT0) rise to 2.5V.
As we back in April where informed that during POR the output…
Part Number: DAC60501DAC60501M and DAC60508M
We shall a new series of low cost single and multichannel ±10V outputs.
During power up the above PN's will reset to mid voltage.
This will then be 1.250V during first power up.
If we then program…
Part Number: DAC60501 Hello Team,
I would like to make sure that our DAC60501ZDQFR has I2C clock stretching function. And then When the slave cannot process the command from the master in time, clock line is stretched when the slave forces the clock…
Part Number: DAC60501 We need a (relatively) cheap DAC to produce a ramp voltage with a update rate of ~1uS per step.Since fully specified 1uS settling voltage DACs are quite expensive, we investigate the possibility to use a little slower device, like…
Part Number: DAC60501 Hello,
After writing 0xFFF value into DAC60501, reading default value which is 0x8000.
We are using linux I2c driver, so there must be not a problem with I2C timing cycle.
Thanks,
Mukesh
Hi Nikolay,
It is also critical to ensure that the loop supply is not referenced to the board's GND(Iret). The loop- node will always be a lower potential than ground. If they are shorted, the current loop will not be able to regulate.
In addition…
Part Number: DAC60501 Hello,
I would like you to confirm about when DACx0501(x = 8,7,6) will be released to market.
Could you please confirm ?
Best Regards,
