Part Number: DAC61408 Tool/software: Hello,
1) can you help to review the schematic?
2) toggle mode register A and register B, where is it? It's not in register map.
3) toggle pin, only 3 pin, does it mean we can pick up 3 of 8 channel use it? …
Part Number: DAC61408 Tool/software: Can I use this part to generate 1KHz PWM, 5V?
It means I will refresh the output every 500us.
-> at time = 0, set output = 0v
->at time = 500us, set output = 5V
->at time = 1ms, set output = 0v
->at time…
Part Number: DAC61408 Other Parts Discussed in Thread: TLC555 , DAC53204 Tool/software: Hi,
I looking to design a half bridge non-controlled LLC converter with fix switching frequency and fix duty cycle 50%, 400V dc bus.
I want to make it as simple…
Part Number: DAC61408 Other Parts Discussed in Thread: DAC61404 , DAC81408 Tool/software: We are looking at replacing a older parallel DAC with the DAC61408. The older DAC has separate power pins for analog ground and digital ground and the existing design…
Part Number: DAC61408 Tool/software: Simulation and circuit design (2).pdf
Hi everyone,
I’ve been troubleshooting an issue for the past couple of weeks where my DAC is not producing any output on any of its 8 channels. I’ve attached simulation snapshots…
Part Number: DAC61408 Tool/software: Hello, This is Kwonjoon Lee from South Korea.
I would like to ask about relationship between power supplies of DAC61408 and issuing of power-on-reset(POR) event.
(Detailed Question)
1. I would like to ask if…
Part Number: DAC81408EVM Hello,
We have purchased DAC61408 Eval board, we need to generate negative output from all 8 channels. we have tried connecting Vss to negative 12V.
still no success. we also looked into register configurations.it didn't…
Part Number: DAC61408 Hi, I would like to know what is the Sample/Update rate of the DAC61408, I could not see it in the datasheet or on the introduction page of the website.
In addition, I would also like to ask the experts, for the "Sample/Update…
Part Number: DAC61408 Dear all,
one of my AA is interested to use the DAC61408 to generate negative voltages.
The min VCC of the DAC61408 is 9V, unfortunately he does not have any rails higher than 5V. Since the output voltages will be only negative…
