Part Number: DAC714DAC714 datasheet is has spec for 1 LSB step settling time of 4us. An associated footprint states that : "(5) For the worst-case Binary Two’s Complement code changes: FFFFH to 0000H and 0000H to FFFFH" the 4us is for simple 1 LSB change…
Part Number: DAC714 Tool/software: Hi team,
Customer wants to buy DAC712U-1 from other side to replace DAC712U.
Could you explain -1 and non-1 and what the difference? thanks
Part Number: DAC714 Hello,
Wondering what the differences are between DAC712U and DAC712U-1. We have this part confirmed that the label is accurate from TI, but do not have anything to indicate differences. If this is a customer specific device, please…
Part Number: DAC714
Can someone tell me of the -1 means for this part number DAC712U-1 .
It just do not seem to be able to find this information anywhere other than is not a customer special
Thank you
Part Number: DAC714 Hi,
I found the value of θJA for DAC714U in the datasheet. However, the value of θJC was not found. Do you have data of θJC? If yes, please let me know this value.
Best Regards,
Nishie
Part Number: DAC714 Other Parts Discussed in Thread: DAC8881 , DAC80501
Hello
The characteristic values for gain drift, zero error drift, or full scale error drift were not listed in the DAC714 data sheet. Can you tell me the characteristic values…
Hi Uttam, Thank you for you reply, it took some time to get what the datasheet ment, but also came to the conclusion that it woks with SPI. Maybe you can help me with my followup question aswell. Do I need to do any thin with the A1 (DAC data latch) if…
Part Number: DAC714 Other Parts Discussed in Thread: TINA-TI
Hi,
I was wondering if it would be possible to recommend a circuit, similar to the one shown in Fig. 6B of the datasheet (see reference image below), but for the -10V to 10V output voltage…
Part Number: DAC714 Hi,
Please let me ask basic questions.
From the information of ESP, the MSPS of DAC714 is described as 0.086MSPS. Please tell me how to calculate this value.
※If what clock frequency is input to the CLK terminal will it be 0…
Other Parts Discussed in Thread: DAC714 hello,
I use the DAC714 for my new project. my question is simple, do I need use the CRL pin to clear the registers before each conversion cycle. I shift my data in the shift register, latch it with the A1 control…
