Part Number: DAC71416 Other Parts Discussed in Thread: DAC81416 Tool/software: Hello,
My customer is looking for a DAC that can best satisfy the requirements below.
- Multi CH output(32 channels) : Support as many channels as possible
- High voltage…
Part Number: DAC71416 Tool/software: I would like to ask clarification about the short-circuit current and protection that I found in the datasheet: What happens when I short a DAC output to Ground?
Does a protection kick in, and can it stay shorted indefinitely…
Part Number: DAC71416 Hi,
I'm currently working on DAC71416 interfacing with MSP432P4111 using SPI communication. I enclosed my schematic for verification and code below.
I'm getting the Device ID from DAC perfectly, But when i try to get the output…
Part Number: DAC71416 Hi,
I am trying to configure DAC71416 I am trying to read Device ID but I am not getting the response, I have attached the schematic and MOSI - yellow line and MISO - blue line output
Part Number: DAC71416
Hi,
i am having a problem in getting a output from the DAC0 pin,
i enabled all registers which are needed for the output to come at DAC0.
microcontroller: STM32F103C8T
Vcc = +15v
Vss = -15v
Vaa=Vdd= 5v
Vio= 3.3v
/LDAC = /RESET …
Part Number: DAC71416 HI,
we are trying to design this DAC for Output Range: ±2.5 V, based on the Pin functions [ VCC -> Output positive analog power supply (9 V to 41.5 V). ] do we have to provide 9V in VDD for Output Range: ±2.5 V
Part Number: DAC71416 DAC 71416 is connected to FPGA, using 50 MHz as SCLK, but DAC is not configuring, the supply voltage given to VIO is 3.3 V,
and we are matching the timing requirement also but it is not getting configured. But it is configured with…
Part Number: DAC71416 Hello!
I have recently assembled a new prototype development board for this IC.
I am experiencing some strange results from the DAC outputs with some preliminary software tests. Before I pass this design onto my programming team I…
Part Number: DAC81416EVM Hi,
Can I use DXP with any of the below parts:
1. DAC81416
2. DAC71416
3. DAC61416
If not, can I use the DACx1416 EVM GUI to give a custom code?
Thanks,
Venkata
Part Number: DAC81416EVM the labview runtime is not being detected by the dac evm. i downloaded 2010,2014,2015,2021 runtime engines in NI package
It show in the NI package but it does not show in my control panel and also the dac evm is not able to recognize…
