Hi David,
Yes, the DAC8218, DAC7718, and DAC8718 are pin-to-pin and function-compatible. If you are ok with the slight spec and resolution differences then you will be able to use the devices interchangeably with the same software.
You can see in the…
Other Parts Discussed in Thread: DAC7718 Hi all,
Although I am debugging the substrate in which DAC7718 was carried, Things occurs as follows.
(1) It is since "RESET SEL" and "USB/BTC" are set to IOVdd, At least 8V is outputted although…
Other Parts Discussed in Thread: DAC7718 , REF3220 , LM7705 Hi
I have a DAC7718 in the following configuration:
referenced with a REF3220 (2.048V), gain set to 4, thus 1LSB = 2mV
IOVDD and DVDD tied together to +5V
AVDD to +10V
AVSS to GND
For the entire…
Other Parts Discussed in Thread: DAC7718 Hello there,
Im struggling a to get the DAC7718 running as i wish it to. I am using it in bipolar mode (+-12V supply, 3.3V Interface, 5V Ref, 4x gain, no correction engine). Power Sequencing for proper initialisati…
Other Parts Discussed in Thread: DAC8718 , DAC7718EVM
Hello,
I have a board with a DAC7718 ,
used in bipolar mode (±12V). Other settings: WAKEUP, RST, LDAC, RSTSEL
and USB/BTC are pulled-up. Vref is 2,5V, gain is set to 4x, no
correction engine…
Part Number: DAC8718 Other Parts Discussed in Thread: DAC7718 , Team,
this is a continuation of the previous thread about DAC7718 heating up to 45 degrees C when the negative -5V voltage is applied to AVss (through a 1kOhm resistor).
We now use DAC8718…
Part Number: DAC7718EVM Other Parts Discussed in Thread: DAC7718 Hi,
I'm using the DAC7718 Evaluation Module.
In the User Guide it says that there are "various code examples available" which unfortunately I wasn't able to find online. …
Other Parts Discussed in Thread: DAC7718 , DAC8718 Hi Eugenio,
please do you have any idea because we have presentation in two weeks, where our analogue outputs should be shown. Shall we check if DAC7718 or DAC8718 is running. Nobody would check 12 bits…
Hi Eugenio,
please do you have any idea because we have presentation in two weeks, where our analogue outputs should be shown. Shall we check if DAC7718 or DAC8718 is running. Nobody would check 12 bits only on a presentation. If they would work better…
Other Parts Discussed in Thread: REF3220 , DAC7718 Hi
I'm using a REF3220 to provide the reference voltage to a DAC7718 with OUT_F and OUT_S tied together since the trace length is only about 2cm. The ENABLE pin is pulled down to GND and is raised to +5V…
