Part Number: DAC8814 Tool/software: hi,
DAC8814 uses three channels, and the other channel is not used. How should the unused channel pins Rfb, Iout, and Agnd be handled? Can they float?
Thanks！
Part Number: DAC8814 Other Parts Discussed in Thread: OPA277 , REF102 , TINA-TI Hello ,
I have used DAC8814 IC for one of my designs. The required output voltage is +/-10V. The circuit was designed as per the recommended circuit by datasheet and resistors…
Part Number: DXP Other Parts Discussed in Thread: DAC8814 , DAC8811 NI-VISA driver detected when connected to PC. When DXP is loaded, the device is getting listed in other devices as unknown device, it is not being recognized as USB devices.
Part Number: DAC8814 Hi team,
Use the chip dac8814, and then detect that the output power of IOUT pin is only 2mw. is it normal ? How much is normal?
thanks,
Best regards,
Part Number: DAC8814 Other Parts Discussed in Thread: , DAC11001A , DAC8832 Hi,
I need to generate 2 voltage signals of 500 KHz frequency and +/-5V output range with an accuracy of 16 bits. By going through the products DAC8814 seems good. However unlike…
Part Number: DAC8814 Hi, Is it possible to get a 3D-model? I need to develop a motherboard with appropriate connector (pins) location, so I need to know their coordinates, which is not mentioned in gerb files.
Part Number: DAC8814 Hello, all. I am trying to test whether or not my DAC8814 is functioning properly. The precision Op-amps that were used with it were fried due to being supplied with too much power. I am trying to test it in a configuration similar…
Part Number: DAC8814 Other Parts Discussed in Thread: THS4141 Conditions of use:
1. SPI control output of DAC8814 through SPARAN6 FPGA of XILINX;
2. DAC88144 channels are used for simultaneous output, of which one channel is converted from single…
